VSC OFF Switch Circuit
Circuit diagnosis · Vehicles built Apr 2016 – Dec 2016
Versions by build date: Jan 2015 – Mar 2016 Apr 2016 – Dec 2016 Jan 2017 – Nov 2017 from Dec 2017
DESCRIPTION
The skid control ECU (brake actuator assembly) is connected to the combination meter assembly via CAN communication.Pressing the VSC OFF switch turns off TRC operation, and pressing and holding this switch turns off TRC and VSC operation. If TRC and VSC operations are turned off, the TRC OFF indicator light and the VSC OFF indicator light will come on.
WIRING DIAGRAM


INSPECTION PROCEDURE
- NOTICE:
- When replacing the skid ECU (brake actuator assembly), perform zero point calibration and store system information (Click here).
| 1. CHECK CAN COMMUNICATION SYSTEM |
Check if CAN communication system DTCs are output (Click here).
- Result:
Result
Proceed to
DTC is not output
A
DTC is output
B
|
|
||||
| A | |
| 2. CHECK IF BRAKE ACTUATOR ASSEMBLY CONNECTOR IS SECURELY CONNECTED |
Check if the skid control ECU (brake actuator assembly) connector is securely connected.
- OK:
- The connector is securely connected.
|
|
||||
| OK | |
| 3. READ VALUE USING GTS (TRC/VSC OFF MODE) |
Turn the ignition switch off.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Chassis / ABS/VSC/TRC / Data List.
According to the display on the GTS, read the Data List.
ABS/VSC/TRC Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
TRC/VSC Off Mode
TRC/VSC off mode /
Normal, TRC OFF, Unknown or VSC OFF
NORMAL: Normal mode
TRC OFF: TRC off mode
VSC OFF: VSC off mode
Unknown: Unspecified
Check the indicator light and mode condition on the GTS changes according to VSC OFF switch operation.
- Standard::
Switch Operation
Mode Condition Display
TRC OFF Indicator Light
VSC OFF Indicator Light
Not pressed
Normal
Does not come on
Does not come on
Pressing the VSC OFF switch
TRC OFF
Comes on
Does not come on
Pressing and holding the VSC OFF switch
VSC OFF
Comes on
Comes on
- Result:
Result
Proceed to
Indicator light and mode condition display do not change
A
Mode condition display is normal, but indicator light does not change
B
Indicator light and mode condition display is normal
C
|
|
||||
|
|
||||
| A | |
| 4. PERFORM ACTIVE TEST USING GTS (TRC OFF INDICATOR LIGHT AND VSC OFF INDICATOR LIGHT) |
Turn the ignition switch off.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Chassis / ABS/VSC/TRC / Active Test.
According to the display on the GTS, perform the Active Test.
ABS/VSC/TRC Tester Display
Test Part
Control Range
Diagnostic Note
TRC(TRAC) OFF Indicator Light
TRC OFF indicator light
Indicator light ON/OFF
Observe combination meter assembly
Vehicle condition: Vehicle stopped
VSC OFF Indicator Light
VSC OFF indicator light
Indicator light ON/OFF
Observe combination meter assembly
Vehicle condition: Vehicle stopped
Check the TRC OFF indicator light and VSC OFF indicator light in the combination meter assembly turn on or off in accordance with GTS operation.
- OK:
- The TRC OFF indicator light and VSC OFF indicator light turn on or off in accordance with GTS operation.
|
|
||||
| OK | |
| 5. INSPECT VSC OFF SWITCH |
Turn the ignition switch off.
Remove the VSC OFF switch (Click here).
Inspect the VSC OFF switch (Click here).
- OK:
- The VSC OFF switch operates normally.
|
|
||||
| OK | |
| 6. CHECK HARNESS AND CONNECTOR (VSC OFF SWITCH - BRAKE ACTUATOR ASSEMBLY) |
Disconnect the B92 skid control ECU (brake actuator assembly) connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
B92-33 (CSW) - I34-6
Always
Below 1 Ω
B92-33 (CSW) or I34-6 - Body ground
Always
10 kΩ or higher
I34-3 - Body ground
Always
Below 1 Ω
|
|
||||
| OK | ||
| ||
| 7. INSPECT COMBINATION METER ASSEMBLY |
Turn the ignition switch off.
Perform the Active Test of the combination meter assembly using the GTS (Click here).
Check the combination meter assembly.
- OK:
- The TRC OFF indicator light and VSC OFF indicator light turn on or off in accordance with GTS operation.
|
|
||||
| OK | ||
| ||
