Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
1.INSTALL SCREW GROMMET (for High Roof, 6 Speakers)
Attach the claw to install the 2 screw grommets.
86160Q
2.INSTALL ROOF SPEAKER ASSEMBLY (for High Roof, 6 Speakers)
Install the roof speaker assembly with 2 screws for No. 1 speaker mounting bracket.
3.INSTALL ROOF SPEAKER WITH BRACKET (for High Roof, 6 Speakers)
Attach the guide and claw to install the roof speaker with bracket.
| *A | for LH Side | *B | for RH Side |
Install the 2 screws.
Connect the connector.
| *A | for LH Side | *B | for RH Side |
|
Screw |
|
Connector |
86160Q
4.INSTALL ROOF SPEAKER ASSEMBLY (for Standard Roof, 6 Speakers)
Attach the guide and claw to install the roof speaker assembly.
| *A | for LH Side | *B | for RH Side |
Install the 2 screws.
Connect the connector.
| *A | for LH Side | *B | for RH Side |
|
Screw |
|
Connector |
86160Q
5.INSTALL ROOF SPEAKER ASSEMBLY
for Standard Roof:
Install the roof speaker assembly with the 2 bolts.
for High Roof:
Install the roof speaker assembly with the 2 bolts.
6.INSTALL ROOF SPEAKER WITH BRACKET
for Standard Roof:
Attach the guide and clip and install the roof speaker with bracket.
|
Bolt |
|
Connector |
Install the 2 bolts.
Connect the connector and attach the clamp.
for High Roof:
Attach the guide and install the roof speaker with bracket.
|
Bolt |
|
Connector |
Install the 2 bolts.
Connect the connector and attach the clamp.
7.INSTALL ROOF HEADLINING ASSEMBLY
for Semi-trim:
Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING (for Semi-trim)>INSTALLATION
for Full-trim:
Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING (for Full-trim)>INSTALLATION
8.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL (w/ Airbag System)
for 7GR-FKS:
for 1GD-FTV:
9. INITIALIZATION AFTER RECONNECTING BATTERY TERMINAL (w/ Airbag System)
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE
When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART
10. PERFORM DIAGNOSTIC SYSTEM CHECK (w/ Airbag System)
11.CHECK SRS WARNING LIGHT (w/ Airbag System)
12.INSPECT SEAT BELT WARNING SYSTEM (w/ Seat Belt Warning System)