The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the rear crankshaft oil seal removal/installation are shown below.
When the cable is disconnected / reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is operated normally
| *a | An Object Exceeding Weight Limit of Engine Lifter |
The engine assembly with transmission is very heavy. Be sure to follow the procedure described in the repair manual, or the engine lifter may suddenly drop or the engine assembly may fall off the engine lifter.
To prevent burns, do not touch the engine, exhaust manifold or other high temperature components while the engine is hot.
35000
1.REMOVE AUTOMATIC TRANSMISSION ASSEMBLY (for Automatic Transmission)
33030
2.REMOVE MANUAL TRANSMISSION UNIT ASSEMBLY (for Manual Transmission)
31210
3.REMOVE CLUTCH COVER ASSEMBLY (for Manual Transmission)
Click hereDrivetrain>CLUTCH>CLUTCH UNIT>REMOVAL
31250
4.REMOVE CLUTCH DISC ASSEMBLY (for Manual Transmission)
Click hereDrivetrain>CLUTCH>CLUTCH UNIT>REMOVAL
13405
5.REMOVE FLYWHEEL SUB-ASSEMBLY (for Manual Transmission)
Using SST, hold the crankshaft.
Remove the 8 bolts and flywheel sub-assembly.
Do not reuse the bolts.
Remove the No. 1 crankshaft position sensor plate.
32101
6.REMOVE DRIVE PLATE AND RING GEAR SUB-ASSEMBLY (for Automatic Transmission)
Using SST, hold the crankshaft.
Remove the 8 bolts, rear drive plate spacer, drive plate and ring gear sub-assembly and No. 1 crankshaft position sensor plate.
11381A
7.REMOVE REAR CRANKSHAFT OIL SEAL
| *a | Cut Position |
Using a knife, cut off the lip of the rear crankshaft oil seal.
Using a screwdriver, pry out the rear crankshaft oil seal.
Do not damage the surface of the rear crankshaft oil seal press fit hole or crankshaft.
Tape the screwdriver tip before use.