Home › Drivetrain › CLUTCH › CLUTCH ACCUMULATOR (for 1GD-FTV)
RM35X0E _52 Drivetrain _078837 CLUTCH _0382382 CLUTCH ACCUMULATOR(for 1GD-FTV) A

CLUTCH  CLUTCH ACCUMULATOR(for 1GD-FTV)  INSTALLATION  


PROCEDURE

Hide 31490 1.INSTALL CLUTCH ACCUMULATOR ASSEMBLY

a.

Install the clutch accumulator assembly with the 3 nuts.

Torque:
4.9 N*m (50 kgf*cm, 43 in.*lbf)


b.
C410535C01
1.729,0.427 2.042,0.625 0.313,0.198 10 false *a
*a Torque Wrench Fulcrum Length


Using a union nut wrench, connect the master cylinder to flexible hose tube and accumulator to flexible hose tube.

Torque:
Specified tightening torque : 15.2 N*m (155 kgf*cm, 11 ft.*lbf)

HINT:
·

Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION

·

When using a union nut wrench (fulcrum length of 22 mm (0.8661 in.)) + torque wrench (fulcrum length of 162 mm (6.3779 in.)): 13.4 N*m (137 kgf*cm, 10 ft.*lbf)




Hide 2.BLEED AIR FROM CLUTCH PIPE LINE

Hide 3.CHECK FOR CLUTCH FLUID LEAKAGE

HINT:

Check for leaks in the clutch system.


Hide 4.CHECK FLUID LEVEL IN RESERVOIR

Hide 51773E 5.INSTALL STEP PLATE COVER RH (w/ Cover)

Hide 51408B 6.INSTALL ENGINE UNDER COVER SUB-ASSEMBLY RH (w/ Cover)

Hide 51495 7.INSTALL TRANSMISSION UNDER COVER (w/ Cover)

Hide 51405A 8.INSTALL NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY

Hide 52618 9.INSTALL LOWER FRONT BUMPER ABSORBER

Hide 51406A 10.INSTALL NO. 2 ENGINE UNDER COVER SUB-ASSEMBLY (w/ No. 2 Engine Under Cover Sub-assembly)