Home › Engine / Hybrid System › 1GD-FTV (ENGINE CONTROL) › ECD SYSTEM (w/ Urea SCR System) › 2019.02–2021.07
RM35X0E _51 Engine / Hybrid System _078856 1GD-FTV ENGINE CONTROL _0382589 ECD SYSTEM(w/ Urea SCR System) C

1GD-FTV ENGINE CONTROL  ECD SYSTEM(w/ Urea SCR System)  P204712  Reductant Injection Valve Circuit High Bank 1 Unit 1 Circuit Short to Battery  P204714  Reductant Injection Valve Circuit Low Bank 1 Unit 1 Circuit Short to Ground or Open  


DESCRIPTION

The urea injector opens the needle valve and injects urea solution according to operation signals sent by the urea pump control ECU.

DTC No. Detection Item DTC Detection Condition Trouble Area MIL Memory Note
P204712 Reductant Injection Valve Circuit High Bank 1 Unit 1 Circuit Short to Battery When the urea injector is operating, an open or short circuit occurs in the urea injector circuit for 5 seconds or more (1 trip detection logic).
·

Open or short in urea injector set circuit

·

Urea injector set

·

Urea pump control ECU


Comes on DTC stored SAE Code: P2049
P204714 Reductant Injection Valve Circuit Low Bank 1 Unit 1 Circuit Short to Ground or Open When the urea injector is operating, an open or short circuit occurs in the urea injector circuit for 5 seconds or more (1 trip detection logic).
·

Open or short in urea injector set circuit

·

Urea injector set

·

Urea pump control ECU


Comes on DTC stored SAE Code: P2048

CONFIRMATION DRIVING PATTERN

DTC No. DTC Detection Drive Pattern
P204712
P204714
Reductant Injection Valve (Active Test)

WIRING DIAGRAM

A383041E02
1.25,1.281 1.406,1.479 0.156,0.198 10 false 2 2.531,1.26 2.688,1.458 0.156,0.198 10 false 1 1.385,1.75 2,1.948 0.615,0.198 10 false E86 1.385,1.938 3.99,2.135 2.604,0.198 10 false Urea Injector Set 5.458,0.635 5.615,0.833 0.156,0.198 10 false 8 5.479,1.26 5.635,1.458 0.156,0.198 10 false 7 5.688,0.74 6.302,0.938 0.615,0.198 10 false UIV+ 5.677,1.375 6.292,1.573 0.615,0.198 10 false UIV- 5.375,1.906 5.688,2.104 0.313,0.198 10 false N37 5.385,2.135 7.135,2.323 1.75,0.188 10 false Urea Pump Control ECU

CAUTION / NOTICE / HINT

HINT:

Read freeze frame data using the GTS. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, and other data from the time the malfunction occurred.


PROCEDURE

1.INSPECT UREA INJECTOR SET

Result:
Proceed to
OK
NG



OK

2.CHECK HARNESS AND CONNECTOR (UREA INJECTOR SET - UREA PUMP CONTROL ECU)

NG

7.REPLACE UREA INJECTOR SET
2.CHECK HARNESS AND CONNECTOR (UREA INJECTOR SET - UREA PUMP CONTROL ECU)
a.

Disconnect the urea injector set connector.


b.

Disconnect the urea pump control ECU connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
E86-2 - N37-8 (UIV+) Always Below 1 Ω
E86-1 - N37-7 (UIV-) Always Below 1 Ω
E86-2 or N37-8 (UIV+) - Body ground and other terminals Always 10 kΩ or higher
E86-1 or N37-7 (UIV-) - Body ground and other terminals Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

3.CHECK DTC OUTPUT

NG

6.REPAIR OR REPLACE HARNESS OR CONNECTOR
3.CHECK DTC OUTPUT
a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON and turn the GTS on.


c.

Clear the DTCs.


d.

Turn the ignition switch off for 30 seconds or more.


e.

Turn the ignition switch to ON and turn the GTS on.


f.

Enter the following menus: Powertrain / Engine / Active Test / Reductant Injection Valve.

Powertrain > Engine > Active Test
Tester Display
Reductant Injection Valve
50004 372 82

g.

Perform the Active Test.


h.

Enter the following menus: Powertrain / Engine / Trouble Codes.

Powertrain > Engine > Trouble Codes
50001 372

i.

Read the DTCs.


Result:
Result Proceed to
DTC P204712 or P204714 is output A
No DTC is output B



A

4.REPLACE UREA PUMP CONTROL ECU

B

END

4.REPLACE UREA PUMP CONTROL ECU

Result:
Proceed to
NEXT



NEXT

5.CONFIRM WHETHER MALFUNCTION HAS BEEN SUCCESSFULLY REPAIRED
5.CONFIRM WHETHER MALFUNCTION HAS BEEN SUCCESSFULLY REPAIRED
a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON and turn the GTS on.


c.

Clear the DTCs.

Powertrain > Engine > Clear DTCs
50002 372

d.

Turn the ignition switch off for 30 seconds or more.


e.

Turn the ignition switch to ON and turn the GTS on.


f.

Enter the following menus: Powertrain / Engine / Active Test / Reductant Injection Valve.

Powertrain > Engine > Active Test
Tester Display
Reductant Injection Valve
50004 372 82

g.

Perform the Active Test.


h.

Enter the following menus: Powertrain / Engine / Trouble Codes.

Powertrain > Engine > Trouble Codes
50001 372

i.

Confirm that the DTC is not output again.


Result:
Proceed to
NEXT



NEXT

END

6.REPAIR OR REPLACE HARNESS OR CONNECTOR
a.

Repair or replace the harness or connector.


Result:
Proceed to
NEXT



NEXT

5.CONFIRM WHETHER MALFUNCTION HAS BEEN SUCCESSFULLY REPAIRED
7.REPLACE UREA INJECTOR SET

Result:
Proceed to
NEXT



NEXT

5.CONFIRM WHETHER MALFUNCTION HAS BEEN SUCCESSFULLY REPAIRED