The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the tilt roof glass sub-assembly removal/installation are shown below.
When the cable is disconnected / reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the systems is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (w/ Airbag System)
for 7GR-FKS:
for 1GD-FTV:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
If the airbag deploys for any reason, it may cause a serious accident.
63349A
2.REMOVE REAR ROOF HEADLINING GARNISH
for Semi-trim:
Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING (for Semi-trim)>REMOVAL
for Full-trim:
Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING (for Full-trim)>REMOVAL
63201C
3.REMOVE TILT ROOF GLASS SUB-ASSEMBLY
Be sure to replace the tilt roof glass sub-assembly with a new one.
When separating the tilt roof glass sub-assembly, be careful not to damage the paint or interior and exterior ornaments.
|
Protective Tape |
|
Front Side |
Apply protective tape to the area around the installation position of the tilt roof glass sub-assembly on the vehicle body to prevent it from being scratched.
| *a | Cut |
|
Front Side |
Using a knife, cut off the moulding as shown in the illustration.
| *a | Piano Wire |
| *b | Clip |
|
Front Side |
Pass a piano wire between the vehicle body and tilt roof glass sub-assembly from the interior.
Tie objects that can serve as handles (for example, wooden blocks) to both wire ends.
Cut off the adhesive by pulling the piano wire around the tilt roof glass sub-assembly.
Install the suction cups to the tilt roof glass sub-assembly.
Using suction cups, detach the clip and remove the tilt roof glass sub-assembly.
|
Front Side | - | - |
Do not to drop the tilt roof glass sub-assembly.
Be sure to replace the tilt roof glass sub-assembly with a new one.