Wear protective gloves. Sharp areas on the parts may injure your hands.
There is risk of injury.
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
89178C
1.INSTALL NO. 2 AIRBAG BRACKET
Install the No. 2 airbag bracket to the front seat airbag assembly RH with 2 new nuts.
Do not reuse the nut.
73910B
2.INSTALL FRONT SEAT AIRBAG ASSEMBLY RH
Install the front seat airbag assembly RH together with the No. 2 airbag bracket with a new nut.
Do not reuse the nut.
Connect the airbag wire harness to the seatback side:
When disconnecting the airbag wire harness, take care not to damage the airbag wire harness.
Attach the wire harness clamp.
Connect the airbag wire harness to the seat cushion side:
When disconnecting the airbag wire harness, take care not to damage the airbag wire harness.
Attach the wire harness clamp.
Attach the claw to connect the airbag connector.
71551A
3.INSTALL FRONT SEATBACK PAD RH
79158
4.INSTALL SEATBACK COVER PLATE RH
71073A
5.INSTALL FRONT SEATBACK COVER SUB-ASSEMBLY RH
73240
6.INSTALL FRONT SEAT INNER BELT ASSEMBLY RH
73178A
7.INSTALL SEAT BELT ANCHOR COVER CAP
73373
8.INSTALL REAR SEAT SHOULDER BELT COVER
71811T
9.INSTALL FRONT SEAT CUSHION SHIELD RH
72525M
10.INSTALL RECLINING ADJUSTER RELEASE HANDLE RH
72329D
11.INSTALL SEAT ADJUSTER BOLT COVER RH
12.INSTALL FRONT SEAT ASSEMBLY RH
13.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
for 7GR-FKS:
for 1GD-FTV:
14. INITIALIZATION AFTER RECONNECTING BATTERY TERMINAL
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE
When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART
15.PERFORM DIAGNOSTIC SYSTEM CHECK
16.CHECK SRS WARNING LIGHT
17.PERFORM SYSTEM INITIALIZATION AND CALIBRATION