The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the roof rack bracket removal/installation are shown below.
When the cable is disconnected / reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the systems is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
1. PRECAUTION (w/ Airbag System)
Be sure to read Precaution thoroughly before servicing.
for Type A:
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM (for Type A)>PRECAUTION
for Type B:
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM (for Type B)>PRECAUTION
After the ignition switch is turned off, there may be a waiting time before disconnecting the negative (-) battery terminal.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>BEFORE DISCONNECTING BATTERY
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (w/ Airbag System)
for 7GR-FKS:
for 1GD-FTV:
Wait at least 90 seconds after disconnecting the cable from the negative(-) battery terminal to disable the SRS system.
If the airbag deploys for any reason, it may cause a serious accident.
63185H
3.REMOVE ROOF RACK BRACKET
Remove the 2 bolts and roof rack bracket.
The roof rack bracket and bolt must not be reused.
Use the same procedure for the every roof rack bracket.
4.REMOVE ROOF HEADLINING ASSEMBLY
for Semi-trim:
Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING (for Semi-trim)>REMOVAL
for Full-trim:
Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING (for Full-trim)>REMOVAL
63187A
5.REMOVE REAR ROOF RACK BRACKET (for High Roof)
w/ Wire Harness:
Detach the wire harness clamp.
w/ Wire Harness:
Detach the wire harness clamp.
Using a screwdriver, remove the inner roof rack retainer and rear roof rack bracket.
Tape the screwdriver tip before use.
| *1 | Inner Roof Rack Retainer | - | - |
|
Remove in this Direction |
|
Protective Tape |
63187A
6.REMOVE REAR ROOF RACK BRACKET (for Standard Roof)
w/ Wire Harness:
Detach the wire harness clamp.
w/ Wire Harness:
Detach the wire harness clamp.
Using a screwdriver, remove the inner roof rack retainer and rear roof rack bracket.
Tape the screwdriver tip before use.
| *1 | Inner Roof Rack Retainer | - | - |
|
Remove in this Direction |
|
Protective Tape |