The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the clearance warning buzzer (for RHD) removal/installation are shown below.
When the cable is disconnected / reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is operated normally
Learning completes when vehicle is operated normally
1. PRECAUTION
Be sure to read Precaution thoroughly before servicing.
for Airbag System Type A:
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM (for Type A)>PRECAUTION
for Airbag System Type B:
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM (for Type B)>PRECAUTION
After the ignition switch is turned off, there may be a waiting time before disconnecting the negative (-) battery terminal.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>BEFORE DISCONNECTING BATTERY
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
for 7GR-FKS:
for 1GD-FTV:
Wait at least 90 seconds after disconnecting the cable from the negative(-) battery terminal to disable the SRS system.
If the airbag deploys for any reason, it may cause a serious accident.
67911B
3.REMOVE FRONT DOOR OUTSIDE SCUFF PLATE RH
Use the same procedure described for the LH side.
Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING (for Full-trim)>REMOVAL
67913B
4.REMOVE FRONT DOOR SCUFF PLATE RH
Use the same procedure described for the LH side.
Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING (for Full-trim)>REMOVAL
62111C
5.REMOVE COWL SIDE TRIM BOARD RH
Use the same procedure described for the LH side.
Click hereVehicle Interior>INTERIOR PANELS / TRIM>INSTRUMENT PANEL SAFETY PAD>REMOVAL
55631A
6.REMOVE NO. 1 INSTRUMENT PANEL UNDER TRAY STOPPER
55011A
7.REMOVE NO. 1 INSTRUMENT PANEL GARNISH SUB-ASSEMBLY
55641
8.REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER
53601
9.REMOVE HOOD LOCK CONTROL LEVER SUB-ASSEMBLY
77306
10.REMOVE FUEL LID LOCK OPEN LEVER SUB-ASSEMBLY
55432D
11.REMOVE LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL
55044C
12.REMOVE INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY
55433B
13.REMOVE LOWER NO. 2 INSTRUMENT PANEL FINISH PANEL
73900
14.REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY (w/ Knee Airbag)
55445B
15.REMOVE INSTRUMENT PANEL FINISH PLATE (w/o Knee Airbag)
55313
16.REMOVE LOWER INSTRUMENT PANEL LH (w/o Knee Airbag)
89343C
17.REMOVE NO. 1 CLEARANCE WARNING BUZZER
Detach the clamp and remove the No. 1 clearance warning buzzer.
Disconnect the connector.