The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the tire pressure warning receiver removal/installation are shown below.
63320E
1.REMOVE REAR ROOF HEADLINING ASSEMBLY
for Semi-trim: Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING (for Semi-trim)>REMOVAL
for Full-trim: Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING (for Full-trim)>REMOVAL
89760C
2.REMOVE TIRE PRESSURE WARNING ECU AND RECEIVER
Do not drop the tire pressure warning ECU and receiver, strike it with tools or subject it to impact.
If the tire pressure warning ECU and receiver is subjected to an impact, replace it with a new one.
|
Bolt |
|
Connector |
Remove the 2 bolts.
Detach the 2 guides to disconnect the tire pressure warning ECU and receiver.
Disconnect the connector and remove the tire pressure warning ECU and receiver.