Wear protective gloves. Sharp areas on the parts may injure your hands.
There is risk of injury.
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the front seat 3 point type belt assembly removal/installation are shown below.
When the cable is disconnected / reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the systems is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
1. PRECAUTION (w/ Front Seat Side Airbag)
Be sure to read Precaution thoroughly before servicing.
for Type A:
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM (for Type A)>PRECAUTION
for Type B:
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM (for Type B)>PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>BEFORE DISCONNECTING BATTERY
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (w/ Front Seat Side Airbag)
for 7GR-FKS:
for 1GD-FTV:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
If the airbag deploys for any reason, it may cause a serious accident.
3.REMOVE FRONT SEAT ASSEMBLY RH
72329D
4.REMOVE SEAT ADJUSTER BOLT COVER RH
72525M
5.REMOVE RECLINING ADJUSTER RELEASE HANDLE RH
71811T
6.REMOVE FRONT SEAT CUSHION SHIELD RH
73120
7.REMOVE FRONT SEAT 3 POINT TYPE BELT ASSEMBLY LH (SEAT ANCHOR)
Detach the hook.
w/ Seat Belt Warning System:
| *A | w/ Center Seat Occupant Detection Sensor |
Detach the claw and clamp.
Disconnect the connector.
w/ Center Seat Occupant Detection Sensor:
Disconnect the connector.
Remove the bolt.
|
Band |
Detach the band and remove the seat anchor of the front seat 3 point type belt assembly LH and front seat inner belt assembly RH.
73178A
8.REMOVE SEAT BELT ANCHOR COVER CAP
73373
9.REMOVE REAR SEAT SHOULDER BELT COVER
71073A
10.REMOVE FRONT SEATBACK COVER SUB-ASSEMBLY RH
79158
11.REMOVE SEATBACK COVER PLATE RH
71551A
12.REMOVE FRONT SEATBACK PAD RH
74810L
13.REMOVE FRONT PROTECTOR ASSEMBLY RH
71H75B
14.REMOVE RH SEATBACK FRAME RECLINING ADJUSTER INSIDE COVER
73120
15.REMOVE FRONT SEAT 3 POINT TYPE BELT ASSEMBLY LH
Remove the 3 nuts A and reclining sensor of the front seat 3 point type belt assembly LH.
| *A | for LHD | *B | for RHD |
Remove the 2 nuts B and retractor of the front seat 3 point type belt assembly LH.
Detach the guide and remove the front seat 3 point type belt assembly LH.