Home › Vehicle Interior › DOOR LOCK › DOOR LOCK JUNCTION › 2019.02–2019.06
RM35X0E _58 Vehicle Interior _078336 DOOR LOCK _0390094 DOOR LOCK JUNCTION A

DOOR LOCK  DOOR LOCK JUNCTION  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.

·

Use the same procedure for the RH and LH sides.

·

Use the same procedure described for the RH side.

·

A bolt without a torque specification is shown in the standard bolt chart.

Click hereGeneral>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS



PROCEDURE

Hide 84262B 1.INSTALL SLIDE DOOR CONTROL JUNCTION FEMALE

a.
B540314C01
0,0 0,0 false
V113147

Install in this Direction


for LH Side:

i.

Install the slide door control junction female with the 2 bolts as shown in the illustration.



b.
B540315C01
0,0 0,0 false
V113147

Install in this Direction


for RH Side:

i.

Install the slide door control junction female with the 2 bolts as shown in the illustration.



c.
B539141

Connect the connector and attach the clamp.


Hide 67851E 2.INSTALL SLIDE DOOR SERVICE HOLE COVER RH

Hide 67603 3.INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY RH (for Semi-trim, for Type A)

Hide 67603 4.INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY RH (for Semi-trim, for Type B)

Hide 67680B 5.INSTALL SLIDE DOOR TRIM BOARD ASSEMBLY RH (for Full-trim, for Standard Roof)

Hide 67680B 6.INSTALL SLIDE DOOR TRIM BOARD ASSEMBLY RH (for Full-trim, for High Roof)

Hide 67667A 7.INSTALL SLIDE DOOR WINDOW GARNISH RH (for Full-trim, for Standard Roof)

Hide 67667A 8.INSTALL SLIDE DOOR WINDOW GARNISH RH (for Full-trim, for High Roof)

Hide 84261B 9.INSTALL SLIDE DOOR CONTROL JUNCTION MALE

a.
B540316C01
0,0 0,0 false
V100135

Bolt
V100136

Connector


for LH Side:

i.

Install the slide door control junction male with the 2 bolts as shown in the illustration.


ii.

Connect the connector.



b.
B540317C01
0,0 0,0 false
V100135

Bolt
V100136

Connector


for RH Side:

i.

Install the slide door control junction male with the 2 bolts as shown in the illustration.


ii.

Connect the connector.



Hide 73210 10.INSTALL FRONT SEAT OUTER BELT ASSEMBLY RH

HINT:

Use the same procedure described for the LH side.




Hide 11.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL (w/ Pretensioner and Force Limiter)

Hide 12. INITIALIZATION AFTER RECONNECTING BATTERY TERMINAL

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE

HINT:

When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is usel.

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART


Hide 13. PERFORM DIAGNOSTIC SYSTEM CHECK (w/ Pretensioner and Force Limiter)

Hide 15.INSPECT SEAT BELT WARNING SYSTEM (w/ Seat Belt Warning System)