The urea injector opens the needle valve and injects urea solution according to operation signals sent by the urea pump control ECU.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | MIL | Memory | Note |
|---|---|---|---|---|---|---|
| P204712 | Reductant Injection Valve Circuit High Bank 1 Unit 1 Circuit Short to Battery | When the urea injector is operating, an open or short circuit occurs in the urea injector circuit for 5 seconds or more (1 trip detection logic). | ·
Open or short in urea injector set circuit ·
Urea injector set ·
Urea pump control ECU |
Class A | DTC stored | SAE Code: P2049 |
| P204714 | Reductant Injection Valve Circuit Low Bank 1 Unit 1 Circuit Short to Ground or Open | When the urea injector is operating, an open or short circuit occurs in the urea injector circuit for 5 seconds or more (1 trip detection logic). | ·
Open or short in urea injector set circuit ·
Urea injector set ·
Urea pump control ECU |
Class A | DTC stored | SAE Code: P2048 |
| DTC No. | DTC Detection Drive Pattern |
|---|---|
| P204712
P204714 |
Reductant Injection Valve (Active Test) |
Read freeze frame data using the GTS. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, and other data from the time the malfunction occurred.
Inspect the urea injector set.
Click hereEngine / Hybrid System>1GD-FTV (EMISSION CONTROL)>UREA INJECTOR>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the urea injector set connector.
Disconnect the urea pump control ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| E86-2 - N37-8 (UIV+) | Always | Below 1 Ω |
| E86-1 - N37-7 (UIV-) | Always | Below 1 Ω |
| E86-2 or N37-8 (UIV+) - Body ground and other terminals | Always | 10 kΩ or higher |
| E86-1 or N37-7 (UIV-) - Body ground and other terminals | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Connect the GTS to the DLC3.
Turn the engine switch on (IG) and turn the GTS on.
Clear the DTCs.
Turn the engine switch off for 30 seconds or more.
Turn the engine switch on (IG) and turn the GTS on.
Enter the following menus: Powertrain / Engine and Transmission / Active Test / Reductant Injection Valve.
| Tester Display |
|---|
| Reductant Injection Valve |
Perform the Active Test.
Enter the following menus: Powertrain / Engine and Transmission / Trouble Codes.
Read the DTCs.
| Result | Proceed to |
|---|---|
| DTC P204712 or P204714 is output | A |
| No DTC is output | B |
A
B
Replace the urea pump control ECU.
Click hereEngine / Hybrid System>1GD-FTV (EMISSION CONTROL)>UREA PUMP CONTROL ECU>REMOVAL
| Proceed to |
|---|
| NEXT |
NEXT
Connect the GTS to the DLC3.
Turn the engine switch on (IG) and turn the GTS on.
Clear the DTCs.
Turn the engine switch off for 30 seconds or more.
Turn the engine switch on (IG) and turn the GTS on.
Enter the following menus: Powertrain / Engine and Transmission / Active Test / Reductant Injection Valve.
| Tester Display |
|---|
| Reductant Injection Valve |
Perform the Active Test.
Enter the following menus: Powertrain / Engine and Transmission / Trouble Codes.
Confirm that the DTC is not output again.
| Proceed to |
|---|
| NEXT |
NEXT
Repair or replace the harness or connector.
| Proceed to |
|---|
| NEXT |
NEXT
Replace the urea injector set.
Click hereEngine / Hybrid System>1GD-FTV (EMISSION CONTROL)>UREA INJECTOR>REMOVAL
| Proceed to |
|---|
| NEXT |
NEXT