The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during vane pump assembly removal/installation are shown below.
When the cable is disconnected / reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
When using a vise, do not overtighten it.
When installing the parts indicated by arrows, coat them with power steering fluid.
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>BEFORE DISCONNECTING BATTERY
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
12601B
3.REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY (w/ Cover)
16361A
4.REMOVE FAN AND GENERATOR V BELT
5.DRAIN POWER STEERING FLUID
44348D
6.DISCONNECT NO. 2 OIL RESERVOIR TO PUMP HOSE
Slide the hose clamp and disconnect the No. 2 oil reservoir to pump hose.
Drain the power steering fluid.
44410
7.DISCONNECT PRESSURE FEED TUBE ASSEMBLY
Disconnect the power steering oil pressure switch connector from the power steering oil pressure switch.
Remove the union bolt and disconnect the pressure feed tube assembly from the vane pump assembly.
Remove the gasket from the pressure feed tube assembly.
44310
8.REMOVE VANE PUMP ASSEMBLY
Remove the 2 bolts and vane pump assembly.