Wear protective gloves. Sharp areas on the parts may injure your hands.
There is risk of injury.
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the front seat inner belt assembly removal/installation are shown below.
When the cable is disconnected / reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the systems is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
1. PRECAUTION (w/ Front Seat Side Airbag)
Be sure to read Precaution thoroughly before servicing.
for Type A:
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM (for Type A)>PRECAUTION
for Type B:
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM (for Type B)>PRECAUTION
for Type C:
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM (for Type C)>PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>BEFORE DISCONNECTING BATTERY
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (w/ Front Seat Side Airbag)
for 7GR-FKS:
for 1GD-FTV:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
If the airbag deploys for any reason, it may cause a serious accident.
3.REMOVE FRONT SEAT ASSEMBLY LH
4.REMOVE FRONT SEAT ASSEMBLY RH
Use the same procedure described for the LH side.
71862K
5.REMOVE FRONT SEAT INNER CUSHION SHIELD LH (for Driver Side)
71861K
6.REMOVE FRONT SEAT INNER CUSHION SHIELD RH (for Front Passenger Side)
73240
7.REMOVE FRONT SEAT INNER BELT ASSEMBLY LH (for Driver Side)
w/o Sub Wire Harness:
Detach the claw and clamp.
w/ Sub Wire Harness:
Disconnect the connector.
Detach the claw and clamp.
Remove the nut and front seat inner belt assembly LH.
Remove the front seat belt anchor plate.
73230
8.REMOVE FRONT SEAT INNER BELT ASSEMBLY RH (for Front Passenger Side)
w/ Seat Belt Warning System, w/o Front Seat Side Airbag:
Disconnect the connector.
Detach the clamp and claw.
w/ Seat Belt Warning System, w/ Front Seat Side Airbag:
Disconnect the 2 connectors.
Detach the clamp and claw.
Remove the nut and front seat inner belt assembly RH.
Remove the front seat belt anchor plate.