Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
89120A
1.INSTALL AUTOMATIC LIGHT CONTROL SENSOR (w/ Automatic Light Control System)
Attach the claw to install the automatic light control sensor.
|
Install in this Direction | - | - |
Connect the connector.
88625H
2.INSTALL COOLER THERMISTOR (SOLAR SENSOR) (w/o Automatic Light Control System)
Attach the claw to install the cooler thermistor (solar sensor).
|
Install in this Direction | - | - |
Connect the connector.
55990C
3.INSTALL CENTER DEFROSTER NOZZLE ASSEMBLY
4.INSTALL INSTRUMENT PANEL SAFETY PAD ASSEMBLY
5.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
for 7GR-FKS:
for 1GD-FTV:
6. INITIALIZATION AFTER RECONNECTING BATTERY TERMINAL
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE
When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART
7.PERFORM DIAGNOSTIC SYSTEM CHECK
8.CHECK SRS WARNING LIGHT
9.INSPECT AUTOMATIC LIGHT CONTROL SYSTEM