52021
1.REMOVE FRONT BUMPER REINFORCEMENT SUB-ASSEMBLY
for Wagon:
Click hereVehicle Exterior>EXTERIOR PANELS / TRIM>FRONT BUMPER (for Wagon)>DISASSEMBLY
except Wagon:
Click hereVehicle Exterior>EXTERIOR PANELS / TRIM>FRONT BUMPER (except Wagon)>DISASSEMBLY
51466
2.REMOVE UPPER RADIATOR SUPPORT BRACE LH (for Wagon)
51465
3.REMOVE UPPER RADIATOR SUPPORT BRACE RH (for Wagon)
86520
4.REMOVE LOW PITCHED HORN ASSEMBLY
Click hereVehicle Exterior>HORN>HORN>REMOVAL
86510
5.REMOVE HIGH PITCHED HORN ASSEMBLY (for 2-piece Type)
Click hereVehicle Exterior>HORN>HORN>REMOVAL
88590D
6.REMOVE BLOWER ASSEMBLY WITH SHROUD (w/ Condenser Fan)
for LH Side:
Click hereVehicle Interior>HEATING / AIR CONDITIONING>CONDENSER FAN>REMOVAL
for RH Side:
Click hereVehicle Interior>HEATING / AIR CONDITIONING>CONDENSER FAN>REMOVAL
53510
7.REMOVE HOOD LOCK ASSEMBLY
53209B
8.REMOVE HOOD LOCK SUPPORT BRACE SUB-ASSEMBLY
16546
9.REMOVE RADIATOR PROTECTOR (w/o Air Conditioning System)
17030
10.REMOVE AIR HOSE ASSEMBLY
| *a | Retainer |
Loosen the 2 hose clamps and disconnect the air hose assembly from the turbine outlet elbow.
Remove the 2 bolts and air tube support bracket from the air hose assembly and radiator support.
Release the retainer and disconnect the air hose assembly from the intercooler assembly as shown in the illustration.
Remove the 2 hose clamps from the air hose assembly.
25761B
11.DISCONNECT NO. 1 VACUUM TRANSMITTING HOSE
for Intercooler Assembly Side:
Slide the clip and disconnect the No. 1 vacuum transmitting hose from the intercooler assembly.
for Diesel Throttle Body Side:
Detach the 5 clamps and disconnect the No. 1 vacuum transmitting hose from the air pipe sub-assembly.
Slide the clip and disconnect the No. 1 vacuum transmitting hose from the engine oil dipstick guide.
17303T
12.REMOVE AIR PIPE SUB-ASSEMBLY
| *a | Retainer |
Release the retainers and remove the air pipe sub-assembly from the intake air connector and intercooler assembly as shown in the illustration.
53288B
13.REMOVE RADIATOR SUPPORT EXTENSION LH
| *A | for LHD |
| *B | for RHD |
Detach the 2 claws and remove the radiator support extension LH.
53287B
14.REMOVE RADIATOR SUPPORT EXTENSION RH
| *A | for LHD |
| *B | for RHD |
Detach the 2 claws and remove the radiator support extension RH.
44402
15.DISCONNECT NO. 1 POWER STEERING OIL COOLER SUB-ASSEMBLY
for LHD:
Remove the 3 bolts and disconnect the No. 1 power steering oil cooler sub-assembly from the radiator support.
for RHD:
Remove the 4 bolts and disconnect the No. 1 power steering oil cooler sub-assembly from the radiator support.
17312B
16.REMOVE NO. 2 AIR INLET DUCT
for RH Side:
Detach the 2 claws and remove the No. 2 air inlet duct.
for LH Side:
Detach the 2 claws and remove the No. 2 air inlet duct.
17941
17.REMOVE NO. 1 INTERCOOLER AIR GUIDE
Detach the 2 claws and remove the No. 1 intercooler air guide.
17942
18.REMOVE NO. 2 INTERCOOLER AIR GUIDE
Detach the 2 claws and remove the No. 2 intercooler air guide.
88689E
19.REMOVE NO. 1 COOLER BRACKET
Remove the 2 bolts, 4 nuts and No. 1 cooler bracket from the radiator support.
17940D
20.REMOVE INTERCOOLER ASSEMBLY
Detach the 2 guides and remove the intercooler assembly from the lower radiator support assembly.
Tilt the intercooler assembly and lift up to remove it.
21.REMOVE GROMMET
Remove the 2 grommets from the lower radiator support assembly.