Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
51406A
1.REMOVE NO. 2 ENGINE UNDER COVER SUB-ASSEMBLY (w/ No. 2 Engine Under Cover Sub-assembly)
52618
2.REMOVE LOWER FRONT BUMPER ABSORBER
51405A
3.REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY
4.DRAIN ENGINE COOLANT
5.DRAIN ENGINE COOLANT (for Water Cooled Type Intercooler)
12601B
6.REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY (for Water Cooled Type Intercooler)
53106B
7.REMOVE RADIATOR COVER SUB-ASSEMBLY
for Wagon:
Click hereVehicle Exterior>EXTERIOR PANELS / TRIM>RADIATOR GRILLE (for Wagon)>REMOVAL
except Wagon:
Click hereVehicle Exterior>EXTERIOR PANELS / TRIM>RADIATOR GRILLE (except Wagon)>REMOVAL
17751
8.REMOVE NO. 1 AIR CLEANER INLET
Remove the 2 bolts and No. 1 air cleaner inlet.
44360
9.DISCONNECT VANE PUMP OIL RESERVOIR ASSEMBLY
Remove the 2 bolts.
Detach the clamps and disconnect the vane pump oil reservoir assembly.
17030
10.REMOVE AIR HOSE ASSEMBLY (for Air Cooled Type Intercooler)
16640
11.REMOVE INTERCOOLER RESERVE TANK ASSEMBLY (for Water Cooled Type Intercooler)
Slide the clip and disconnect the No. 2 intercooler cooling water hose from the intercooler reserve tank assembly.
| *1 | No. 1 Intercooler Cooling Water Hose |
|
Clip |
|
Bolt |
Slide the clip and disconnect the No. 1 intercooler cooling water hose from the intercooler assembly.
Detach the clamp.
Remove the 2 bolts and intercooler reserve tank assembly.
16470
12.REMOVE RADIATOR RESERVE TANK ASSEMBLY
Slide the clip and disconnect the No. 2 water by-pass hose from the radiator reserve tank assembly.
| *1 | No. 1 Water By-pass Hose |
|
Clip |
|
Bolt |
Slide the clip and disconnect the No. 1 water by-pass hose from the radiator assembly.
Remove the 2 bolts and radiator reserve tank assembly.
16571C
13.REMOVE NO. 1 RADIATOR HOSE
Slide the clips and remove the No. 1 radiator hose from the radiator assembly and water outlet sub-assembly.
16552C
14.REMOVE NO. 2 INTERCOOLER COOLING WATER HOSE (for Water Cooled Type Intercooler)
Detach the clamps.
Slide the clip and remove the No. 2 intercooler cooling water hose from the electric water pump assembly.
165A0
15.REMOVE NO. 1 INTERCOOLER COOLING WATER HOSE ASSEMBLY (for Water Cooled Type Intercooler)
Slide the clips and disconnect the No.1 intercooler cooling water hose assembly from the electric water pump assembly and intercooler cooling radiator assembly.
Detach the clamp and remove the No.1 intercooler cooling water hose assembly from the fan shroud.
161B0
16.REMOVE ELECTRIC WATER PUMP ASSEMBLY (for Water Cooled Type Intercooler)
|
Connector |
|
Bolt |
Disconnect the connector.
Remove the 2 bolts and electric water pump assembly.
88359
17.REMOVE VISCOUS HEATER V BELT (w/ Viscous Heater)
16515A
18.DISCONNECT INTERCOOLER COOLING WATER PIPE ASSEMBLY (for Water Cooled Type Intercooler)
Detach the clamps and disconnect the intercooler cooling water pipe assembly from the fan shroud.
16711
19.REMOVE FAN SHROUD
| *1 | No. 2 Water By-pass Hose |
Slide the clip and disconnect the No. 2 water by-pass hose from the radiator assembly.
for Water Cooled Type Intercooler:
Detach the clamps.
Loosen the 4 nuts holding the fan with fluid coupling assembly.
Remove the fan and generator V belt.
Detach the claws.
for Automatic Transmission:
Detach the clamp and disconnect the oil cooler inlet hose.
Remove the 4 nuts of the fan with fluid coupling assembly.
Detach the guides.
|
Remove in this Direction |
Remove the fan shroud together with the fluid coupling assembly as shown in the illustration.
Do not allow the radiator assembly to interfere with other parts.
Remove the fan pulley from the water pump assembly.
16572D
20.REMOVE NO. 2 RADIATOR HOSE
Slide the clips and remove the No. 2 radiator hose from the radiator assembly and water inlet.
21.REMOVE FRONT BUMPER
for Wagon:
Click hereVehicle Exterior>EXTERIOR PANELS / TRIM>FRONT BUMPER (for Wagon)>REMOVAL
except Wagon:
Click hereVehicle Exterior>EXTERIOR PANELS / TRIM>FRONT BUMPER (except Wagon)>REMOVAL
53510
22.REMOVE HOOD LOCK ASSEMBLY
17311B
23.REMOVE NO. 1 AIR INLET DUCT
Remove the clips.
Detach the claws, guides and remove the No. 1 air inlet duct.
53286F
24.REMOVE RADIATOR SIDE AIR SEAL LH (for Wagon)
Detach the claw, clip and remove the radiator side air seal LH.
53285N
25.REMOVE RADIATOR SIDE AIR SEAL RH (for Wagon)
Detach the claws and remove the radiator side air seal RH.
51466
26.REMOVE UPPER RADIATOR SUPPORT BRACE LH (for Wagon)
51465
27.REMOVE UPPER RADIATOR SUPPORT BRACE RH (for Wagon)
86520
28.REMOVE LOW PITCHED HORN ASSEMBLY
Click hereVehicle Exterior>HORN>HORN>REMOVAL
86510
29.REMOVE HIGH PITCHED HORN ASSEMBLY (for 2-piece Type)
Click hereVehicle Exterior>HORN>HORN>REMOVAL
88590E
30.REMOVE BLOWER ASSEMBLY WITH SHROUD (w/ Condenser Fan)
for LH Side:
Click hereVehicle Interior>HEATING / AIR CONDITIONING>CONDENSER FAN>REMOVAL
for RH Side:
Click hereVehicle Interior>HEATING / AIR CONDITIONING>CONDENSER FAN>REMOVAL
53209B
31.REMOVE HOOD LOCK SUPPORT BRACE SUB-ASSEMBLY
| *1 | Engine Room Main Wire |
for Wagon:
Detach the clamps and disconnect the engine room main wire.
| *1 | Engine Room Main Wire |
except Wagon:
Disconnect the connector.
Detach the clamps and disconnect the engine room main wire.
w/ Air Conditioning System:
| *1 | Air Conditioner Tube and Accessory Assembly |
Detach the clamp and disconnect the air conditioner tube and accessory assembly.
Remove the 2 bolts and hood lock support brace sub-assembly.
16546
32.REMOVE RADIATOR PROTECTOR (w/o Air Conditioning System)
Remove the 2 bolts.
Detach the guides and remove the radiator protector.
53205
33.REMOVE UPPER RADIATOR SUPPORT SUB-ASSEMBLY
| *1 | Engine Room Main Wire |
Remove the bolt and disconnect the engine room main wire.
for LHD:
| *1 | Engine Room Main Wire |
| *2 | Hood Lock Control Cable Assembly |
Remove the 4 bolts.
Detach the clamps and disconnect the engine room main wire and hood lock control cable assembly and remove the upper radiator support sub-assembly.
Do not allow the cooler condenser assembly to interfere with the radiator assembly. (w/ Air Conditioning System)
for RHD:
| *1 | Engine Room Main Wire |
| *2 | Hood Lock Control Cable Assembly |
Remove the 4 bolts.
Detach the clamps and disconnect the engine room main wire and hood lock control cable assembly and remove the upper radiator support sub-assembly.
Do not allow the cooler condenser assembly to interfere with the radiator assembly. (w/ Air Conditioning System)
32921D
34.DISCONNECT OIL COOLER INLET HOSE (for Automatic Transmission)
Slide the clip and disconnect the oil cooler inlet hose from the radiator assembly.
32922A
35.DISCONNECT OIL COOLER OUTLET HOSE (for Automatic Transmission)
Slide the clip and disconnect the oil cooler outlet hose from the radiator assembly.
16400
36.REMOVE RADIATOR ASSEMBLY
w/ Air Conditioning System:
|
Remove in this Direction |
Remove the radiator assembly from the vehicle as shown in the illustration.
Perform the following procedure with 2 or more people to prevent damage to the radiator assembly.
When removing the radiator assembly, do not damage the cooler condenser assembly.
Prepare a drain pan or cloth in case the coolant leaks.
w/o Air Conditioning System:
|
Remove in this Direction |
Remove the radiator assembly from the vehicle as shown in the illustration.
Perform the following procedure with 2 or more people to prevent damage to the radiator assembly.
Prepare a drain pan or cloth in case the coolant leaks.
16523A
37.REMOVE RADIATOR SUPPORT CUSHION
Remove the 2 radiator support cushions from the radiator assembly.
16535
38.REMOVE LOWER RADIATOR SUPPORT
Remove the 2 lower radiator supports from the radiator assembly.