2007-2013 Highlander Kluger · Service Manual BRAKE

HOW TO PROCEED WITH TROUBLESHOOTING

Troubleshooting · Vehicles built Aug 2008 – Jun 2010

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 Jul 2010 – Jun 2012 from Jul 2012

HINT:
*: Use the intelligent tester.


1.VEHICLE BROUGHT TO WORKSHOP
    NEXT

    2.CUSTOMER PROBLEM ANALYSIS
    1. Interview the customer and confirm the problem (Click here).

      HINT:
      Interview the customer to confirm the following:

      1. History of brake fluid replacement.
      2. Whether the engine was stopped intentionally when driving.
      3. Whether the brake and accelerator pedals were depressed simultaneously.

    NEXT

    3.CHECK DTC AND FREEZE FRAME DATA*
    1. Check and record DTCs and Freeze Frame Data.

    2. Clear the DTCs and Freeze Frame Data (Click here for DTC Check/Clear, or Click here for Freeze Frame Data).

    3. Reconfirm the DTCs.

      1. Reconfirm the DTCs based on the recorded DTCs and Freeze Frame Data (Click here for DTC Check/Clear, or Click here for Freeze Frame Data).

        HINT:
        1. When DTCs indicating CAN communication system malfunctions are output, repair the CAN communication system before repairing each corresponding sensor (Click here).
        2. If any of DTCs U0100, U0123, U0124, and U0126 is output together with a CAN communication DTC, first check the appropriate sensor for a momentary open circuit (Click here).


        Result:
        Result
        Proceed to
        DTC is output
        A
        DTC is not output (Problem symptom does not occur)
        B
        DTC is not output (Problem symptom occurs)
        C


    B.

    C.
    A

    4.DIAGNOSTIC TROUBLE CODE CHART
    1. Proceed to Diagnostic Trouble Code Chart (Click here).

    NEXT

    5.SYMPTOM SIMULATION
    1. Proceed to Diagnosis System (Click here).

    NEXT

    6.PROBLEM SYMPTOMS TABLE
    1. Proceed to Problem Symptoms Table (Click here).

    NEXT

    7.CIRCUIT INSPECTION*
      NEXT

      8.IDENTIFICATION OF PROBLEM
        NEXT

        9.REPAIR OR REPLACEMENT
          NEXT

          10.CONFIRMATION TEST*
            NEXT

            ← HOW TO PROCEED WITH TROUBLESHOOTING (May 2007 – Jul 2008)HOW TO PROCEED WITH TROUBLESHOOTING (Jul 2010 – Jun 2012) →