Home › BRAKE › BRAKE CONTROL › VEHICLE STABILITY CONTROL SYSTEM
ABS Warning Light does not Come ON
Circuit diagnosis · Vehicles built Aug 2008 – Jun 2010
Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 Jul 2010 – Jun 2012 from Jul 2012
DESCRIPTION
The skid control ECU is connected to the combination meter via CAN communication. WIRING DIAGRAM
Refer to ABS Warning Light Remains ON (Click here ). INSPECTION PROCEDURE
NOTICE:
When replacing the brake actuator assembly, perform zero point calibration (Click here ).
1. CHECK CAN COMMUNICATION SYSTEM
Check if a CAN communication system DTC is output (Click here ).
Result:
Result
Proceed to
DTC is not output
A
DTC is output
B
B
A
2. CHECK ABS WARNING LIGHT
Disconnect the skid control ECU connector.
Turn the ignition switch on (IG).
Check that the ABS warning light comes on.
OK:
The ABS warning light comes on.
HINT:
If troubleshooting has been carried out according to the Problem Symptoms Table, refer back to the table and proceed to the next step before replacing the part (Click here ).
NG
OK
3. INSPECT COMBINATION METER ASSEMBLY
Turn the ignition switch off.
Reconnect the skid control ECU connector.
Perform the Active Test of the combination meter (meter CPU) using the intelligent tester (Click here ).
Check the combination meter.
OK:
The ABS warning light turns on or off in accordance with the intelligent tester operation.
HINT:
If troubleshooting has been carried out according to the Problem Symptoms Table, refer back to the table and proceed to the next step (Click here ).
NG
OK