2007-2013 Highlander Kluger · Service Manual BRAKE

ABS Warning Light does not Come ON

Circuit diagnosis · Vehicles built from Jul 2012

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 Jul 2010 – Jun 2012 from Jul 2012

DESCRIPTION

The skid control ECU is connected to the combination meter via CAN communication.

WIRING DIAGRAM

Refer to ABS Warning Light Remains ON (Click here).

INSPECTION PROCEDURE

NOTICE:
When replacing the brake actuator assembly, perform zero point calibration (Click here).


1. CHECK CAN COMMUNICATION SYSTEM
  1. Check if a CAN communication system DTC is output (Click here).

    Result:
    Result
    Proceed to
    DTC is not output
    A
    DTC is output
    B



B
INSPECT CAN COMMUNICATION SYSTEM (Click here)
A


2. CHECK ABS WARNING LIGHT
  1. Disconnect the skid control ECU connector.

  1. Turn the ignition switch on (IG).

  1. Check that the ABS warning light comes on.

    OK:
    The ABS warning light comes on.

    HINT:
    If troubleshooting has been carried out according to the Problem Symptoms Table, refer back to the table and proceed to the next step before replacing the part (Click here).



NG
Go to step 3
OK

REPLACE BRAKE ACTUATOR ASSEMBLY (Click here)

3. INSPECT COMBINATION METER ASSEMBLY
  1. Turn the ignition switch off.

  1. Reconnect the skid control ECU connector.

  1. Perform the Active Test of the combination meter (meter CPU) using the intelligent tester (Click here).

  1. Check the combination meter.

    OK:
    The ABS warning light turns on or off in accordance with the intelligent tester operation.

    HINT:
    If troubleshooting has been carried out according to the Problem Symptoms Table, refer back to the table and proceed to the next step (Click here).



NG
REPLACE COMBINATION METER ASSEMBLY (Click here)
OK

REPLACE BRAKE ACTUATOR ASSEMBLY (Click here)


← ABS Warning Light does not Come ON (Jul 2010 – Jun 2012)Brake Warning Light Remains ON (May 2007 – Jul 2008) →