2007-2013 Highlander Kluger · Service Manual BODY ELECTRICAL

HOW TO PROCEED WITH TROUBLESHOOTING

Troubleshooting · Vehicles built from Jul 2012

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 Jul 2010 – Jun 2012 from Jul 2012

HINT:
Use the following procedure to troubleshoot the navigation system (for DVD).


1.VEHICLE BROUGHT TO WORKSHOP
    NEXT

    2.INSPECT BATTERY VOLTAGE
    1. Inspect the battery voltage.

      Standard Voltage:
      11 to 14 V

      If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.

    NEXT

    3.DIAGNOSTIC QUESTIONING AND SYMPTOM CONFIRMATION
    1. Ask the customer about symptoms and confirm malfunctions.

      Result:
      Result
      Proceed to
      Other symptoms occurred
      A
      The screen displays nothing.
      B


    B.
    A

    4.OPERATION CHECK
    1. Refer to Check System Normal Condition (Click here).

      Result:
      Result
      Proceed to
      Symptom is not normal operation.
      A
      Symptom is normal operation.
      B


    B.
    A

    5.CHECK FOR DTC
    1. Refer to DTC Check/Clear (Click here).

      Result:
      Result
      Proceed to
      DTC is output.
      A
      DTC is not output.
      B


    B.
    A

    6.DTC CLEAR
    1. Clear the DTCs and finish the diagnostic mode.

      HINT:
      The current DTCs may not indicate actual malfunctions depending on the vehicle operating conditions.

    NEXT

    7.RECHECK FOR DTC

      Result:
      Result
      Proceed to
      DTC is output.
      A
      DTC is not output.
      B

      HINT:
      1. Even if the malfunction symptom is not confirmed, check for diagnostic trouble codes. This is because the system stores history diagnostic trouble codes.
      2. Refer to the detailed description on the diagnostic screen as necessary (Click here).
      3. Check the diagnostic trouble code and inspect the area that the code indicates.


    B.
    A

    8.DIAGNOSTIC TROUBLE CODE CHART
    1. Find the output code in Diagnostic Trouble Code Chart (Click here).


    NEXT.
    9.PROBLEM SYMPTOMS TABLE
    1. Refer to Problem Symptoms Table (Click here).

      Result:
      Result
      Proceed to
      Fault is not listed in Problem Symptoms Table.
      A
      Fault is listed in Problem Symptoms Table.
      B

      HINT:
      If the symptom does not recur and no DTC is output, attempt to reproduce (Click here).


    B.
    A

    10.PERFORM TROUBLESHOOTING BASED ON MALFUNCTION SYMPTOM
    1. Refer to Terminals of ECU (Click here).

    NEXT

    11.CHECK THE CIRCUIT
    1. Adjust, repair or replace as necessary.

    NEXT

    12.RECHECK FOR DIAGNOSTIC TROUBLE CODE

      HINT:
      After clearing the DTCs, recheck for DTCs.

    NEXT

    13.PERFORM CONFIRMATION TEST
      NEXT

      ← HOW TO PROCEED WITH TROUBLESHOOTING (Jul 2010 – Jun 2012)IDENTIFICATION OF NOISE SOURCE (May 2007 – Jun 2010) →