2007-2013 Highlander Kluger · Service Manual BODY ELECTRICAL

HOW TO PROCEED WITH TROUBLESHOOTING

Troubleshooting · Vehicles built May 2007 – Jul 2008

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 Jul 2010 – Jun 2012 from Jul 2012


1.VEHICLE BROUGHT INTO A WORKSHOP
    NEXT

    2.DIAGNOSTIC QUESTIONING AND SYMPTOM CONFIRMATION
    1. Ask the customer about symptoms and confirm malfunctions.


    .

    .
    3.CONFIRM THE SYSTEM NORMAL CONDITION
    1. Refer to the "SYSTEM NORMAL CONDITION CHECK" (Click here).


    .

    .
    4.CHECK FOR DTC
    1. Refer to the "DTC CHECK / CLEAR" (Click here).

    2. HINT:
      If the system cannot enter the diagnostic mode, inspect the AVC-LAN and all the components that connect to the AVC-LAN for short circuits and repair or replace the problem part (Click here).


    .

    .
    5.DTC CLEAR
    1. Clear the DTCs and finish the diagnostic mode.

      HINT:
      The currently output DTCs may not indicate actual malfunctions depending on the vehicle conditions.

    NEXT

    6.RECHECK FOR DTC

      HINT:
      1. If the system cannot enter the diagnostic mode, inspect the AVC-LAN and all the components that connect to the AVC-LAN for short circuits.
      2. Even if the malfunction symptom is not confirmed, check for diagnostic trouble codes. This is because the system stores past diagnostic trouble codes.
      3. Refer to the detailed description on the diagnostic screen as necessary (Click here).
      4. Check the diagnostic trouble code and inspect the area the code indicates.


    .

    .
    7.DIAGNOSTIC TROUBLE CODE CHART
    1. Find the output code in the diagnostic trouble code chart (Click here).


    NEXT.
    8.PROBLEM SYMPTOMS TABLE
    1. Find the applicable symptom in the problem symptoms table (Click here).

      HINT:
      If the symptom does not recur and no code is output, perform the symptom reproduction method (Click here).


    .

    .
    9.CHECK THE ECU TERMINAL ARRANGEMENT BASED ON THE MALFUNCTION SYMPTOM
    1. Refer to the "TERMINALS OF ECU" (Click here).

    NEXT

    10.CHECK THE CIRCUIT
    1. Adjust, repair, or replace as necessary.

    NEXT

    11.RECHECK FOR DIAGNOSTIC TROUBLE CODE

      HINT:
      After deleting the DTCs, recheck for diagnostic trouble codes.

    NEXT

    12.PERFORM CONFIRMATION TEST
      NEXT

      ← SYSTEM DESCRIPTION (from Jul 2010)HOW TO PROCEED WITH TROUBLESHOOTING (Aug 2008 – Jun 2010) →