If the system cannot enter the diagnostic mode, inspect the AVC-LAN and all the components that connect to the AVC-LAN for short circuits and repair or replace the problem part (Click here).
.
.
5.DTC CLEAR
Clear the DTCs and finish the diagnostic mode.
HINT:
The currently output DTCs may not indicate actual malfunctions depending on the vehicle conditions.
NEXT
6.RECHECK FOR DTC
HINT:
If the system cannot enter the diagnostic mode, inspect the AVC-LAN and all the components that connect to the AVC-LAN for short circuits.
Even if the malfunction symptom is not confirmed, check for diagnostic trouble codes. This is because the system stores past diagnostic trouble codes.
Refer to the detailed description on the diagnostic screen as necessary (Click here).
Check the diagnostic trouble code and inspect the area the code indicates.
.
.
7.DIAGNOSTIC TROUBLE CODE CHART
Find the output code in the diagnostic trouble code chart (Click here).
NEXT.
8.PROBLEM SYMPTOMS TABLE
Find the applicable symptom in the problem symptoms table (Click here).
HINT:
If the symptom does not recur and no code is output, perform the symptom reproduction method (Click here).
.
.
9.CHECK THE ECU TERMINAL ARRANGEMENT BASED ON THE MALFUNCTION SYMPTOM