HOW TO PROCEED WITH TROUBLESHOOTING
Troubleshooting · Vehicles built from Jul 2010
Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010
- HINT:
- Use the following procedure to troubleshoot the power window control system.
- The intelligent tester should be used in steps 4 and 6.
- Use the following procedure to troubleshoot the power window control system.
| 1.VEHICLE BROUGHT TO WORKSHOP |
| |||||
| 2.CUSTOMER PROBLEM ANALYSIS CHECK |
- In troubleshooting, confirm that the problem symptoms have been accurately identified. Preconceptions should be discarded in order to make an accurate judgment. To clearly understand what the problem symptoms are, it is extremely important to ask the customer about the problem and the conditions at the time the malfunction occurred.
- Gather as much information as possible for reference. Past problems that seem unrelated may also help in some cases.
- The following 5 items are important points in the problem analysis:
What
Vehicle model, system name
When
Date, time, occurrence frequency
Where
Road conditions
Under what conditions?
Driving conditions, weather conditions
How did it happen?
Problem symptoms
| |||||
| 3.INSPECT BATTERY VOLTAGE |
Measure the battery voltage.
- Standard voltage:
- 11 to 14 V
| |||||
| 4.CHECK FOR DTC |
Check for DTCs and note any codes that are output (Click here).
Delete DTCs.
Recheck for DTCs.
- Result:
Result
Proceed to
No DTCs output
A
DTCs output
B
(Click here)
|
|||||
| |||||
| 5.PROBLEM SYMPTOMS TABLE |
- Result:
Result
Proceed to
Fault is not listed in problem symptoms table
A
Fault is listed in problem symptoms table
B
|
|||||
| |||||
| 6.OVERALL ANALYSIS AND TROUBLESHOOTING |
Data List/Active Test (Click here)
Circuit inspection
Terminal of ECU (Click here)
| |||||
| 7.ADJUST, REPAIR OR REPLACE |
| |||||
| 8.RESET POWER WINDOW MOTOR |
- HINT:
- Click here.
| |||||