2007-2013 Highlander Kluger · Service Manual BODY ELECTRICAL

B15A0 LAN Master Malfunction

Diagnostic trouble codes · Vehicles built from Jul 2010

Also covers:

DESCRIPTION

These DTCs are stored when a malfunction occurs in the navigation receiver assembly.
DTC No.
DTC Detection Condition
Trouble Area
B15A0
When either condition below is met:
  1. Bus malfunction
  2. EEPROM error
Navigation receiver assembly
B15AD
When one of the conditions below is met:
  1. A short to ground, short to +B or open occurs in the gyro signal circuit
  2. Gyro sensor malfunction
  3. GPS receiver malfunction
B15B0
Picture circuit (TFT unit) malfunction
B15B3
When one of the conditions below is met:
  1. AM tuner PLL is unlocked
  2. FM tuner PLL is unlocked
  3. Tuner malfunction
B15B4
When one of the conditions below is met:
  1. Mechanism drive signal malfunction
  2. Load/Eject malfunction
  3. Read mechanism malfunction
  4. Mechanical malfunction
B15B7
"Bluetooth" module malfunction

INSPECTION PROCEDURE


1. CHECK DTC
  1. Clear the DTCs (Click here).

  1. Recheck for DTCs and check if the same DTC is output again.

    OK:
    No DTCs are output.



NG
REPLACE NAVIGATION RECEIVER ASSEMBLY (Click here)
OK

USE SIMULATION METHOD TO CHECK (Click here)


← B1585 USB Media Malfunction (from Jul 2010)B15B8 Harddisk Malfunction (Jul 2010 – Jun 2012) →