2007-2013 Highlander Kluger · Service Manual BODY ELECTRICAL

B1585 USB Media Malfunction

Diagnostic trouble codes · Vehicles built from Jul 2010

DESCRIPTION

This DTC is stored when a malfunction occurs in a connected device.
DTC No.
DTC Detection Condition
Trouble Area
B1585
USB Device Malfunction
  1. Non mass-storage class or incompatible protocol USB device
  2. USB device with an incompatible file system, corrupted or incompatible File Allocation Table (FAT)
  3. "iPod" malfunction
  4. "iPod" with unsupported firmware
  5. Unsupported "iPod" model
  1. USB device or "iPod"
  2. Multi-media interface ECU

INSPECTION PROCEDURE


1. REPLACE USB DEVICE OR “iPod”
  1. Disconnect the USB device or "iPod" from the No. 1 stereo jack adapter assembly.

  1. Turn the ignition switch off.

    HINT:
    When one of these DTCs has been stored, it is necessary to turn off the ignition switch to make it possible for the vehicle to recognize a new device when it is connected.

  1. Turn the ignition switch to ACC.

  1. Connect a known good USB device or "iPod" to the No. 1 stereo jack adapter assembly.

    HINT:
    1. If the malfunction occurred when a USB device was in use, use another USB device for the inspection. If the malfunction occurred when an "iPod" was in use, use another "iPod" for the inspection.
    2. Refer to System Description for compatible formats and versions (Click here).


NEXT


2. CLEAR DTC
  1. Clear the DTCs (Click here).


NEXT


3. RECHECK DTC
  1. Recheck for DTCs and check if the same DTC is output again.

    HINT:
    If DTCs are detected frequently, replace the multi-media interface ECU.

    OK:
    No DTCs are output.



NG
REPLACE MULTI-MEDIA INTERFACE ECU (Click here)
OK

USB DEVICE FORMAT WAS INCOMPATIBLE, "iPod" VERSION WAS INCOMPATIBLE, OR USB DEVICE OR "iPod" WAS DEFECTIVE


← B156B Multi-media Interface ECU Disconnected (+ B156E) (from Jul 2010)B15A0 LAN Master Malfunction (+ 5 more codes) (from Jul 2010) →