HOW TO PROCEED WITH TROUBLESHOOTING
Troubleshooting · Vehicles built Aug 2008 – Jun 2010
Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010
- HINT:
- Use the following procedure to troubleshoot the engine immobiliser system.
- Intelligent tester should be used in steps 5, 6, and 8.
- Use the following procedure to troubleshoot the engine immobiliser system.
| 1.VEHICLE BROUGHT TO WORKSHOP |
| |||||
| 2.CUSTOMER PROBLEM ANALYSIS CHECK |
- HINT:
- In troubleshooting, confirm that the problem symptoms have been accurately identified. Preconceptions should be discarded in order to make an accurate judgment. To clearly understand what the problem symptoms are, it is extremely important to ask the customer about the problem and the conditions at the time the malfunction occurred.
- Gather as much information as possible for reference. Past problems that seem unrelated may also help in some cases.
- The following 5 items are important points in the problem analysis:
- In troubleshooting, confirm that the problem symptoms have been accurately identified. Preconceptions should be discarded in order to make an accurate judgment. To clearly understand what the problem symptoms are, it is extremely important to ask the customer about the problem and the conditions at the time the malfunction occurred.
| What |
Vehicle model, system name |
| When |
Date, time, occurrence frequency |
| Where |
Road conditions |
| Under what conditions? |
Driving conditions, weather conditions |
| How did it happen? |
Problem symptoms |
| |||||
| 3.INSPECT BATTERY VOLTAGE |
Measure the battery voltage.
- Standard voltage:
- 11 to 14 V
| |||||
| 4.CRANK ENGINE FOR MORE THAN 10 SECONDS |
| |||||
| 5.CHECK FOR DTCS |
Check for DTCs and note any codes that are output (Click here).
Delete the DTCs.
Recheck for DTCs. Try to duplicate the DTCs (SFI system and engine immobiliser system) by simulating the symptoms indicated by the DTCs.
- Result:
Result
Proceed to
DTC (SFI system) recurs
A
(Click here)
DTC (engine immobiliser system) recurs
B
(Click here)
DTC does not recur
C
|
|||||
|
|||||
| |||||
| 6.READ VALUE ON INTELLIGENT TESTER |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to the ON position.
Turn the tester on.
Select Key SW in the Data List and read the tester display.
Immobiliser (Transponder Key ECU): Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
Key SW
Unlock warning switch signal/ON or OFF
ON: Key is in ignition key cylinder
OFF: No key is in ignition key cylinder
-
- OK:
- ON (Key is in ignition key cylinder) appears on the screen.
|
|||||
| |||||
| 7.PROBLEM SYMPTOMS TABLE |
- Result:
Result
Proceed to
Fault is listed in problem symptoms table
A
Fault is not listed in problem symptoms table
B
|
|||||
| |||||
| 8.OVERALL ANALYSIS AND TROUBLESHOOTING |
DATA LIST / ACTIVE TEST (Click here)
TERMINALS OF ECU (Click here)
| |||||
| 9.ADJUST, REPAIR OR REPLACE |
| |||||
| 10.CONFIRMATION TEST |
| |||||