2007-2013 Highlander Kluger · Service Manual SECURITIES

B2797 Communication Malfunction No. 1

Diagnostic trouble codes · Vehicles built from Jul 2010

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010

DESCRIPTION

This DTC is output when an error occurs in communication between the transponder key amplifier and the transponder key ECU.

HINT:
Some noise is found in the communication line.

DTC No.
DTC Detection Condition
Trouble Area
B2797
Keys are positioned too close to each other, or noise occurs in communication line
  1. Key
  2. Transponder key amplifier
  3. Transponder key ECU assembly

WIRING DIAGRAM

B164251E06

INSPECTION PROCEDURE

NOTICE:
If the transponder key ECU is replaced, register the key and ECU communication ID.


1. CHECK KEYS

  1. B072873E02
    Check whether the ignition key being used is near other ignition keys, as shown in the illustration. Also, check whether the key ring is in contact with the key grip.

    Result:
    Result
    Proceed to
    Key is not near other keys and key ring is not in contact with key grip.
    A
    Key is near other keys and/or key ring is in contact with key grip.
    B



A
Go to step 3
B


2. CHECK DTC OUTPUT
  1. Separate the keys from each other, or remove the key ring.

  1. Delete the DTCs (Click here).

  1. Insert a key into the ignition key cylinder and remove the key. Repeat for all the other keys of the vehicle.

    OK:
    B2797 output does not recur.



NG
Go to step 3
OK

END (KEYS ARE POSITIONED TOO CLOSE TO EACH OTHER)

3. REPLACE TRANSPONDER KEY AMPLIFIER
  1. Replace the transponder key amplifier (Click here).


NEXT


4. CHECK DTC OUTPUT
  1. Delete the DTCs (Click here).

  1. Recheck for DTCs.

    OK:
    B2797 output does not recur.



NG
REPLACE TRANSPONDER KEY ECU ASSEMBLY
OK

END (TRANSPONDER KEY AMPLIFIER IS DEFECTIVE)


← B2797 Communication Malfunction No. 1 (Aug 2008 – Jun 2010)B2799 Engine Immobiliser System Malfunction (May 2007 – Jul 2008) →