B2799 Engine Immobiliser System Malfunction
Diagnostic trouble codes · Vehicles built May 2007 – Jul 2008
Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010
DESCRIPTION
This DTC is output when one of the following occurs: 1) the ECM detects errors in its own communications with the transponder key ECU; 2) the ECM detects errors in the communication lines; or 3) the ECU communication ID between the transponder key ECU and ECM is different and an engine start is attempted. Before troubleshooting for this DTC, make sure no transponder key ECU DTCs are present. If present, troubleshoot the transponder key ECU DTCs first.| DTC No. |
DTC Detection Condition |
Trouble Area |
| B2799 |
One of following conditions is met:
|
|
WIRING DIAGRAM


INSPECTION PROCEDURE
- NOTICE:
- If the transponder key ECU is replaced, register the key and ECU communication ID.
- If the ECM is replaced, register the ECU communication ID.
- If the transponder key ECU is replaced, register the key and ECU communication ID.
| 1. CHECK DTC OUTPUT |
Delete the DTCs (Click here).
Recheck for DTCs.
- OK:
- B2799 output does not recur.
|
|
||||
| OK | ||
| ||
| 2. RE-REGISTER ECU COMMUNICATION ID |
Re-register the ECU communication ID.
| NEXT | |
| 3. CHECK DTC OUTPUT |
Delete the DTCs (Click here).
Recheck for DTCs.
- OK:
- B2799 output does not recur.
|
|
||||
| OK | ||
| ||
| 4. CHECK CONNECTION OF CONNECTOR |
Turn the ignition switch off.
Check that the connectors are properly connected to the ECM and the transponder key ECU.
- OK:
- Connectors are properly connected.
|
|
||||
| OK | |
| 5. CHECK HARNESS AND CONNECTOR (TRANSPONDER KEY ECU - ECM) |
Disconnect the transponder key ECU and ECM connectors.


Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Connection
Condition
Specified Condition
D37-12 (EFII) - D32-15 (IMO)
Always
Below 1 Ω
D37-13 (EFIO) - D32-16 (IMI)
Always
Below 1 Ω
D37-12 (EFII) - Body ground
Always
10 kΩ or higher
D37-13 (EFIO) - Body ground
Always
10 kΩ or higher
|
|
||||
| OK | |
| 6. REPLACE ECM |
Replace the ECM (Click here).
| NEXT | |
| 7. REGISTER ECU COMMUNICATION ID |
Register the ECU communication ID.
| NEXT | |
| 8. CHECK DTC OUTPUT |
Delete the DTCs (Click here).
Recheck for DTCs.
- OK:
- B2799 output does not recur.
|
|
||||
| OK | ||
| ||
