2007-2013 Highlander Kluger · Service Manual BRAKE

C1232 Acceleration Sensor Stuck Malfunction

Diagnostic trouble codes · Vehicles built May 2007 – Jul 2008

Also covers:

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010

DESCRIPTION

The skid control ECU receives signals from the yaw rate and acceleration sensor via the CAN communication system.
The yaw rate sensor has a built-in acceleration sensor and detects the vehicle's condition using 2 circuits (GL1, GL2).
If there is trouble in the bus lines between the yaw rate and acceleration sensor and the CAN communication system, DTCs U0123 (malfunction in CAN communication with the yaw rate sensor) and U0124 (malfunction in CAN communication with the acceleration sensor) are set.
These DTCs are also output when calibration has not been completed.
DTC Code
DTC Detection Condition
Trouble Area
C1232
At a vehicle speed of 10 km/h (6 mph) or more, acceleration sensor output value does not change for 30 seconds or more.
  1. Sensor installation
  2. Yaw rate and acceleration sensor
C1243
While the vehicle speed changes from 30 km/h (19 mph) to 0 km/h (0 mph), the condition that the value of acceleration sensor does not change by 0.0294 G or more occurs 16 times or more.
  1. Sensor installation
  2. Yaw rate and acceleration sensor
C1245
At a vehicle speed of 30 km/h (19 mph) or more, the difference between the forward and backward G calculated from the acceleration sensor value and that calculated from the vehicle speed sensor exceeds 0.35 G for 60 seconds or more.
  1. Sensor installation
  2. Yaw rate and acceleration sensor

WIRING DIAGRAM

C167661E02

INSPECTION PROCEDURE

NOTICE:
When replacing the yaw rate and acceleration sensor, perform zero point calibration (Click here).

HINT:
When U0123, U0124 and/or U0126 is output together with C1232, C1243, and/or C1245, inspect and repair the trouble areas indicated by U0123, U0124 and/or U0126 first (Click here).


1. CHECK YAW RATE AND ACCELERATION SENSOR INSTALLATION
  1. Check that the yaw rate and acceleration sensor has been installed properly (Click here).

    OK:
    The sensor should be tightened to the specified torque.
    The sensor should not be installed in a tilted position.

    NOTICE:
    Check the yaw rate and acceleration sensor signal after replacement (Click here).

    HINT:
    If troubleshooting has been carried out according to the Problem Symptoms Table, refer back to the table and proceed to the next step (Click here).



NG
INSTALL YAW RATE AND ACCELERATION SENSOR CORRECTLY (Click here)
OK

REPLACE YAW RATE AND ACCELERATION SENSOR (Click here)


← C1210 Zero Point Calibration of Yaw Rate Sensor Undone (+ C1336) (from Jul 2010)C1232 Acceleration Sensor Stuck Malfunction (+ C1243, C1245) (Aug 2008 – Jun 2010) →