Home › STEERING › POWER STEERING › POWER STEERING SYSTEM
HOW TO PROCEED WITH TROUBLESHOOTING
Troubleshooting · Vehicles built May 2007 – Jul 2008
Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 Jul 2010 – Jun 2012 from Jul 2012
HINT:
Perform troubleshooting in accordance with the following flowchart.
*: Use the intelligent tester.
1.VEHICLE BROUGHT TO WORKSHOP
NEXT
2.INSPECT BATTERY VOLTAGE
Standard voltage:
11 to 14 V
If the voltage is below 11 V, recharge or replace the battery before proceeding.
NEXT
3.CHECK DTC AND FREEZE FRAME DATA*
NEXT
4.PROBLEM SYMPTOM CONFIRMATION
NEXT
5.CHECK CAN COMMUNICATION SYSTEM*
Check for DTCs (Click here ).
Result:
Result
Proceed to
CAN system DTC is not output
A
CAN system DTC is output
B
HINT:
When any CAN communication system DTCs are output, perform troubleshooting on the CAN communication system first.
When communication to the power steering ECU is not established through the intelligent tester, inspect terminals SIL of the DLC3 and the power steering ECU, and the IG circuit of the power steering ECU.
B.
A
Check for DTCs (Click here ).
Result:
Result
Proceed to
DTC is not output
A
DTC is output
B
B.
A
Problem Symptoms Table (Click here ).
Result:
Result
Proceed to
Fault is not listed in problem symptoms table
A
Fault is listed in problem symptoms table
B
B.
A
8.OVERALL ANALYSIS AND TROUBLESHOOTING*
TERMINALS OF ECU (Click here ).
DATA LIST / ACTIVE TEST (Click here ).
NEXT
NEXT
NEXT