2007-2013 Highlander Kluger · Service Manual ENGINE

P0116 Engine Coolant Temperature Circuit Range / Performance Problem

Diagnostic trouble codes · Vehicles built from Jul 2010

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010

DESCRIPTION

Refer to DTC P0115 (Click here).
DTC No.
DTC Detection Condition
Trouble Area
P0116
When either of following conditions met (2 trip detection logic):
  1. When cold engine started and engine warmed up, engine coolant temperature sensor value does not change.
  2. After warmed up engine started, engine coolant temperature sensor value does not change when engine stopped and then next cold engine start performed.
  1. Thermostat
  2. Engine coolant temperature sensor

INSPECTION PROCEDURE

HINT:
  1. If any of DTC P0115, P0117 or P0118 are set simultaneously with DTC P0116, the engine coolant temperature sensor may have an open or a short circuit. Troubleshoot those DTCs first.
  2. Read freeze frame data using the intelligent tester. The ECM records vehicle and driving condition information as freeze frame data the moment a DTC is stored. When troubleshooting, freeze frame data can be helpful in determining whether the vehicle was running or stopped, whether the engine was warmed up or not, whether the air fuel ratio was lean or rich, as well as other data recorded at the time of a malfunction.


1. CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P0166)
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch on (IG).

  1. Turn the tester on.

  1. Enter the following menus: Powertrain / Engine and ECT / DTC.

  1. Read the DTC.

    Result:
    Display (DTC output)
    Proceed to
    P0116
    A
    P0116 and other DTCs
    B

HINT:
If any DTCs other than P0116 are output, troubleshoot those DTCs first.



B
GO TO DTC CHART (Click here)
A


2. INSPECT THERMOSTAT
  1. Remove the thermostat (Click here).

  1. Check the valve opening temperature of the thermostat.

    Standard:
    80 to 84°C (176 to 183°F)

    HINT:
    In addition to the above check, confirm that the valve is completely closed when the temperature is below the standard.

  1. Reinstall the thermostat (Click here).



NG
REPLACE THERMOSTAT (Click here)
OK

REPLACE ENGINE COOLANT TEMPERATURE SENSOR (Click here)


← P0116 Engine Coolant Temperature Circuit Range / Performance Problem (Aug 2008 – Jun 2010)P0120 Throttle / Pedal Position Sensor / Switch "A" Circuit (+ 6 more codes) (May 2007 – Jul 2008) →