Touch Sensor Circuit
Circuit diagnosis · Vehicles built from Jul 2010
Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010
DESCRIPTION
When the power back door ECU receives a jam signal from the touch sensor while the power back door closer is operating, the ECU reverses the back door operation and opens the door.WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. READ VALUE USING INTELLIGENT TESTER (POWER BACK DOOR TOUCH SENSOR) |
Check the Data List for proper functioning of the power back door touch sensor.
Back door (Power back door ECU) Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
PBD Touch Sen L
Power back door touch sensor LH signal / ON or OFF
ON: Power back door touch sensor is LH pressed
OFF: Power back door touch sensor is LH not pressed
-
PBD Touch Sen R
Power back door touch sensor RH signal / ON or OFF
ON: Power back door touch sensor RH is pressed
OFF: Power back door touch sensor RH is not pressed
-
- OK:
- The display is as specified in the normal condition.
|
|
||||
| OK | ||
| ||
| 2. INSPECT POWER BACK DOOR TOUCH SENSOR |
Remove the power back door touch sensor. (Click here)

Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Connection
Condition
Specified Condition
1 - 2
Not pressed
Approx. 1 kΩ
1 - 2
Pressed
Below 100 Ω
|
|
||||
| OK | |
| 3. CHECK HARNESS AND CONNECTOR (POWER BACK DOOR TOUCH SENSOR - POWER BACK DOOR DRIVE UNIT AND BODY GROUND) |
LH Side

Disconnect the T7 sensor connectors.
Disconnect the O14 ECU connector.
Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Connection
Condition
Specified Condition
T7-1 (OSL) - O14-15 (OSL)
Always
Below 1 Ω
T7-2 (OSLE) - O14-14 (OSE)
Always
Below 1 Ω
T7-1 (OSL) - Body ground
Always
10 kΩ or higher
T7-2 (OSLE) - Body ground
Always
Below 1 Ω
RH Side

Disconnect the T8 sensor connectors.
Disconnect the O14 ECU connector.
Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Connection
Condition
Specified Condition
T8-1 (OSR) - O14-13 (OSR)
Always
Below 1 Ω
T8-2 (OSRE) - O14-14 (OSE)
Always
Below 1 Ω
T8-1 (OSR) - Body ground
Always
10 kΩ or higher
T8-2 (OSRE) - Body ground
Always
Below 1 Ω
|
|
||||
| OK | ||
| ||
