P0660 Intake Manifold Tuning Valve Control Circuit / Open (Bank 1)
Diagnostic trouble codes · Vehicles built May 2007 – Jul 2008
Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010
DESCRIPTION
This circuit opens and closes the intake air control valve in response to changes in the engine load in order to increase the intake efficiency acoustic control induction system.When the engine speed is between 0 and 4450 rpm and the throttle valve opening angle is 60°C or more, the ECM supplies current to the actuator (ON status), to close the intake air control valve. Under other conditions, the VSV is usually OFF and the intake air control valve is open.


| DTC No. |
DTC Detection Condition |
Trouble Area |
| P0660 |
The following conditions are met simultaneously for 0.5 seconds or more (2 trip detection logic):
|
|
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. PERFORM ACTIVE TEST USING INTELLIGENT TESTER |
Connect the intelligent tester to the DLC3.
Start the engine and turn the intelligent tester on.
Select the following menu items: Power train / Engine / Active Test / Activate the VSV for Intake Control.
Check if operating noise can be heard when operating the intake control valve using the intelligent tester.
- OK:
- Operating noise can be heard.
|
|
||||
| OK | ||
| ||
| 2. CHECK INTAKE AIR CONTROL VALVE (INTAKE AIR CONTROL OPERATION) |
Disconnect the air intake valve connector.

Apply battery voltage between the terminals of the air intake valve connector.
Check the air intake valve operation.
- OK:
- Operational noise can be heard.
|
|
||||
| OK | |
| 3. INSPECT TERMINAL VOLTAGE (INTAKE AIR CONTROL VALVE CONNECTOR) |
Disconnect the intake air control valve connection.

Turn the ignition switch on (IG).
Measure the voltage according to the value(s) in the table below.
- Standard voltage:
Tester Connection
Switch Condition
Specified Condition
2 - Body ground
Ignition switch on (IG)
9 to 14 V
Reconnect the intake air control valve connector.
|
|
||||
| OK | |
| 4. CHECK HARNESS AND CONNECTOR (INTAKE AIR CONTROL VALVE - ECM) |
Disconnect the intake air control valve connector.

Disconnect the ECM connector.
Measure the resistance according to the value(s) in the table below.
- Standard resistance (Check for open):
Tester Connection
Condition
Specified Condition
B28-1 - B1-33 (ACIS)
Always
Below 1 Ω
- Standard resistance (Check for short):
Tester Connection
Condition
Specified Condition
B28-1 or B1-33 (ACIS) - B3-1 (E1)
Always
10 kΩ or higher
Reconnect the intake air control valve connector.
Reconnect the ECM connector.
|
|
||||
| OK | ||
| ||
