2007-2013 Highlander Kluger · Service Manual SECURITIES

B2799 Engine Immobiliser System Malfunction

Diagnostic trouble codes · Vehicles built Aug 2008 – Jun 2010

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010

DESCRIPTION

This DTC is output when one of the following occurs: 1) the ECM detects errors in its own communications with the transponder key ECU; 2) the ECM detects errors in the communication lines; or 3) the ECU communication ID between the transponder key ECU and ECM is different and an engine start is attempted. Before troubleshooting for this DTC, make sure no transponder key ECU DTCs are present. If present, troubleshoot the transponder key ECU DTCs first.
DTC No.
DTC Detection Condition
Trouble Area
B2799
One of following conditions is met:
  1. Error in communication between ECM and transponder key ECU
  2. Error in communication lines
  3. Communication ID is different during communication with transponder key ECU
  1. Wire harness or connector
  2. ECM
  3. Transponder key ECU assembly

WIRING DIAGRAM

B151007E14

INSPECTION PROCEDURE

NOTICE:
  1. If the transponder key ECU is replaced, register the key and ECU communication ID.
  2. If the ECM is replaced, register the ECU communication ID.


1. CHECK DTC OUTPUT
  1. Delete the DTCs (Click here).

  1. Recheck for DTCs.

    OK:
    B2799 output does not recur.



NG
Go to step 2
OK

USE SIMULATION METHOD TO CHECK (Click here)

2. RE-REGISTER ECU COMMUNICATION ID
  1. Re-register the ECU communication ID.


NEXT


3. CHECK DTC OUTPUT
  1. Delete the DTCs (Click here).

  1. Recheck for DTCs.

    OK:
    B2799 output does not recur.



NG
Go to step 4
OK

END (PROBLEM WITH ECU COMMUNICATION ID IS DEFECTIVE)

4. CHECK CONNECTION OF CONNECTOR
  1. Turn the ignition switch off.

  1. Check that the connectors are properly connected to the ECM and the transponder key ECU.

    OK:
    Connectors are properly connected.



NG
CONNECT CONNECTORS PROPERLY
OK


5. CHECK HARNESS AND CONNECTOR (TRANSPONDER KEY ECU - ECM)

  1. Disconnect the transponder key ECU and ECM connectors.B171358E02

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    D37-12 (EFII) - D32-15 (IMO)
    Always
    Below 1 Ω
    D37-13 (EFIO) - D32-16 (IMI)
    Always
    Below 1 Ω
    D37-12 (EFII) - Body ground
    Always
    10 kΩ or higher
    D37-13 (EFIO) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


6. REPLACE ECM
  1. Replace the ECM (Click here).


NEXT


7. REGISTER ECU COMMUNICATION ID
  1. Register the ECU communication ID.


NEXT


8. CHECK DTC OUTPUT
  1. Delete the DTCs (Click here).

  1. Recheck for DTCs.

    OK:
    B2799 output does not recur.



NG
REPLACE TRANSPONDER KEY ECU ASSEMBLY
OK

END (ECM IS DEFECTIVE)


← B2799 Engine Immobiliser System Malfunction (May 2007 – Jul 2008)B2799 Engine Immobiliser System Malfunction (from Jul 2010) →