2007-2013 Highlander Kluger · Service Manual SECURITIES

B2799 Engine Immobiliser System Malfunction

Diagnostic trouble codes · Vehicles built from Jul 2010

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010

DESCRIPTION

This DTC is output when one of the following occurs: 1) the ECM detects errors in its own communications with the transponder key ECU assembly; 2) the ECM detects errors in the communication lines; or 3) the ECU communication ID between the transponder key ECU assembly and ECM is different and an engine start is attempted. Before troubleshooting this DTC, make sure no transponder key ECU assembly DTCs are present. If present, troubleshoot the transponder key ECU assembly DTCs first.
DTC No.
DTC Detection Condition
Trouble Area
B2799
One of following conditions is met:
  1. Error in communication between ECM and transponder key ECU assembly
  2. Error in communication lines
  3. Communication ID is different between ECM and transponder key ECU assembly during communication
  1. Wire harness or connector
  2. ECM
  3. Transponder key ECU assembly

WIRING DIAGRAM

B151007E55

INSPECTION PROCEDURE

NOTICE:
  1. If the transponder key ECU assembly is replaced, register the key and ECU communication ID.
  2. If the ECM is replaced, register the ECU communication ID.


1. CHECK DTC OUTPUT
  1. Clear the DTCs (Click here).

  1. Recheck for DTCs.

    OK:
    B2799 is not output.



NG
Go to step 2
OK

USE SIMULATION METHOD TO CHECK (Click here)

2. RE-REGISTER ECU COMMUNICATION ID
  1. Re-register the ECU communication ID.


NEXT


3. CHECK DTC OUTPUT
  1. Clear the DTCs (Click here).

  1. Recheck for DTCs.

    OK:
    B2799 is not output.



NG
Go to step 4
OK

END (PROBLEM WITH ECU COMMUNICATION ID IS DEFECTIVE)

4. CHECK CONNECTION OF CONNECTOR
  1. Turn the ignition switch off.

  1. Check that the connectors are properly connected to the ECM and the transponder key ECU assembly.

    OK:
    Connectors are properly connected.



NG
CONNECT CONNECTORS PROPERLY
OK


5. CHECK HARNESS AND CONNECTOR (TRANSPONDER KEY ECU - ECM)
  1. Disconnect the transponder key ECU assembly and ECM connectors.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    D37-12 (EFII) - D55-20 (IMO)
    Always
    Below 1 Ω
    D37-13 (EFIO) - D55-14 (IMI)
    Always
    Below 1 Ω
    D37-12 (EFII) - Body ground
    Always
    10 kΩ or higher
    D37-13 (EFIO) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


6. REPLACE ECM
  1. Replace the ECM (Click here).


NEXT


7. REGISTER ECU COMMUNICATION ID
  1. Register the ECU communication ID.


NEXT


8. CHECK DTC OUTPUT
  1. Clear the DTCs (Click here).

  1. Recheck for DTCs.

    OK:
    B2799 is not output.



NG
REPLACE TRANSPONDER KEY ECU ASSEMBLY
OK

END (ECM WAS DEFECTIVE)


← B2799 Engine Immobiliser System Malfunction (Aug 2008 – Jun 2010)B279A Theft Deterrent System Communication Line High Fixation (from Jul 2010) →