Television Camera ECU Communication Error
Circuit diagnosis · Vehicles built Aug 2008 – Jun 2010
Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010
INSPECTION PROCEDURE
| 1. IDENTIFY THE COMPONENT SHOWN BY SUB-CODE |
 |
- Enter the diagnostic mode.
Press the "LAN Mon" switch to change the mode to "LAN Monitor" mode.
Identify the component shown by the sub-code.
- HINT:
- "110 (multi-display)" is the component shown by the sub-code in the example shown in the illustration.
- The sub-code will be indicated by its physical address.
- For the component list, refer to "DIAGNOSIS DISPLAY DETAILED DESCRIPTION" (Click here).
| NEXT |
|
 |
|
| 2. CHECK POWER SOURCE CIRCUIT OF COMPONENT SHOWN BY SUB-CODE |
 |
Inspect the power source circuit of the component shown by the sub-code.If the power source circuit is operating normally, proceed to the next step.
Component Table:
Component
|
Proceed to
|
140 (Navigation receiver assembly)
|
Navigation receiver assembly power source circuit (Click here)
|
| NEXT |
|
 |
|
| 3. INSPECT NAVIGATION RECEIVER ASSEMBLY |
 |
- Disconnect navigation receiver assembly connector E2.
Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Connection
|
Condition
|
Specified Condition
|
E2-9 (TX+) - E2-10 (TX-)
|
Always
|
60 to 80 Ω
|
|
NG |
 |
|
|
|
| OK |
|
 |
|
| 4. CHECK HARNESS AND CONNECTOR (TELEVISION CAMERA ECU - COMPONENT SHOWN BY SUB-CODE) |
 |
- HINT:
- Start the check from the circuit that is near the component shown by the sub-code first.
- For details of the connectors, refer to "TERMINALS OF ECU" (Click here).
Referring to the AVC-LAN wiring diagram below, check the AVC-LAN circuit between the television camera ECU and the component shown by the sub-code.
Disconnect all connectors between the television camera ECU and the component shown by the sub-code.
Check for an open or short in the AVC-LAN circuit between the television camera ECU and the component shown by the sub-code.

- OK:
- There are no open or short circuits.
|
NG |
 |
|
| REPAIR OR REPLACE HARNESS OR CONNECTOR |
|
|
| OK |
|
 |
|
| 5. REPLACE COMPONENT SHOWN BY SUB-CODE |
 |
Replace the component shown by the sub-code with a normal one and check if the same problem occurs again.
- OK:
- Same problem does not occur.
|
NG |
 |
|
|
|
| OK |
|
 |
|
|