2007-2013 Highlander Kluger · Service Manual SECURITIES

B279A Theft Deterrent System Communication Line High Fixation

Diagnostic trouble codes · Vehicles built from Jul 2010

DESCRIPTION

If the communication line (EFIO-IMI) to the transponder key ECU assembly is stuck high (e.g. shorted to +B), the ECM stores this DTC.
DTC No.
DTC Detection Condition
Trouble Area
B279A
Communication line (EFIO-IMI) between the ECM and transponder key ECU assembly is stuck high.
  1. Wire harness or connector
  2. Transponder key ECU assembly
  3. ECM

WIRING DIAGRAM

B203372E45

INSPECTION PROCEDURE

NOTICE:
  1. If the transponder key ECU assembly is replaced, register the key and ECU communication ID.
  2. If the ECM is replaced, register the ECU communication ID.


1. CHECK DTC OUTPUT
  1. Recheck for DTCs (Click here).

    HINT:
    If any DTCs other than DTC B279A are output, troubleshoot those DTCs first.

    Result:
    Result
    Proceed to
    DTC B279A is output
    A
    DTC B279A and other DTCs are output
    B



B
GO TO DTC CHART (Click here)
A


2. CHECK HARNESS AND CONNECTOR (TRANSPONDER KEY ECU - ECM)
  1. Disconnect the transponder key ECU assembly connector.

  1. Disconnect the ECM connector.

  1. Measure the resistance and voltage according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    D37-13 (EFIO) - D55-14 (IMI)
    Always
    Below 1 Ω
    D37-13 (EFIO) - Body ground
    Always
    10 kΩ or higher

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    D37-13 (EFIO) - Body ground
    Always
    Below 1 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3. CHECK TRANSPONDER KEY ECU ASSEMBLY (OUTPUT)
  1. Reconnect the transponder key ECU assembly connector.

  1. Reconnect the ECM connector.

  1. B203488E06
    Using an oscilloscope, check the waveform.

    Waveform 1 (Reference):
    Item
    Content
    Terminal No. (Symbol)
    D37-13 (EFIO) - D37-16 (GND)
    Tool Setting
    2 V/DIV., 1 sec./DIV.
    Condition
    Ignition switch ON

    OK:
    Waveform is output normally (see illustration).

    Text in Illustration 
    *1
    Component with harness connected
    (Transponder Key ECU Assembly)
    *2
    GND
    *3
    HIGH
    *4
    LOW



NG
Go to step 4
OK

REPLACE ECM (Click here)

4. REPLACE TRANSPONDER KEY ECU ASSEMBLY
  1. Replace the transponder key ECU assembly.


NEXT


5. REGISTER KEY
  1. Register the key.


NEXT


6. REGISTER ECU COMMUNICATION ID
  1. Register the ECU communication ID.


NEXT


7. CHECK DTC OUTPUT
  1. Clear the DTCs (Click here).

  1. Recheck for DTCs.

    OK:
    DTC B279A is not output.



NG
REPLACE ECM (Click here)
OK

END (TRANSPONDER KEY ECU WAS DEFECTIVE)


← B2799 Engine Immobiliser System Malfunction (from Jul 2010)B279C Theft Deterrent System Presence Detection (from Jul 2010) →