2007-2013 Highlander Kluger · Service Manual ENGINE

ON-VEHICLE INSPECTION

Inspection · Vehicles built from Jul 2010

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010


CHECK ENGINE OIL LEVEL
  1. Warm up the engine, stop it and wait 5 minutes. The oil level should be between the dipstick's low level mark and full level mark.
    If the engine oil level is low, check for leakage and add oil up to the full level mark.

    NOTICE:
    Do not add engine oil to above the full level mark.


CHECK ENGINE OIL
  1. Check the engine oil for deterioration, water contamination, discoloring or thinning.
    If the condition is visibly poor, replace the engine oil and engine oil filter.


CHECK OIL PRESSURE
  1. Remove the oil pressure switch assembly. (Click here)

  1. A244002
    Install the oil pressure gauge with adapter.

  1. Warm up the engine.

  1. Check the oil pressure.

    Standard oil pressure:
    Engine Condition
    Oil Pressure
    Idle
    80 kPa (0.8 kgf/cm2, 11.6 psi) or more
    3000 rpm
    380 kPa (3.9 kgf/cm2, 55.1 psi) or more

    If the oil pressure is not as specified, check the oil pump (Click here).

  1. Remove the oil pressure gauge with adapter.

  1. Install the oil pressure switch assembly. (Click here)

← ON-VEHICLE INSPECTION (Aug 2008 – Jun 2010)COMPONENTS (from May 2007) →