2007-2013 Highlander Kluger · Service Manual STEERING

REASSEMBLY

Removal / installation · Vehicles built May 2007 – Jul 2008

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010


1. INSTALL STEERING PAD ATTACHING SCREW

  1. C165714
    Install the 2 steering pad attaching screws to the lower steering wheel boss cover.


2. INSTALL LOWER STEERING WHEEL BOSS COVER

  1. C165713
    Engage the 4 claws to install the lower steering wheel boss cover to the steering wheel spoke sub-assembly.

  1. C165712
    Install the 2 screws.


3. INSTALL STEERING PAD SWITCH ASSEMBLY (w/ Steering Pad Switch)

  1. E150586
    Engage the 2 pins and install the steering pad switch.

  1. Install the screw.

    Torque:
    2.4 N*m{ 24 kgf*cm , 21 in.*lbf }

  1. E150585
    Engage the 2 pins and install the steering pad switch assembly.

  1. Install the screw.

    Torque:
    2.4 N*m{ 24 kgf*cm , 21 in.*lbf }

  1. Connect the pad switch connector to the spiral cable.


4. INSTALL NO. 2 STEERING WHEEL ORNAMENT (w/o Steering Pad Switch)

  1. C165711
    Engage the 2 pins to install the No. 2 steering wheel ornament to the steering wheel spoke sub-assembly.

  1. C165710
    Install the screw.

    Torque:
    2.4 N*m{ 25 kgf*cm , 21 in.*lbf }


5. INSTALL NO. 1 STEERING WHEEL ORNAMENT (w/o Steering Pad Switch)

HINT:
Perform the same procedure as for the No. 2 steering wheel ornament.


6. INSTALL CRUISE CONTROL MAIN SWITCH (w/ Cruise Control System)

  1. E150162
    Install the cruise control main switch as shown in the illustration.

  1. Connect the connector.

  1. E150160
    Install the 2 screws.

    Torque:
    2.4 N*m{ 25 kgf*cm , 21 in.*lbf }

← DISASSEMBLY (from Jul 2010)REASSEMBLY (Aug 2008 – Jun 2010) →