Home › SECURITIES › ENGINE IMMOBILISER › ENGINE IMMOBILISER SYSTEM (w/ Smart Key System)

DTC    B2799    Engine Immobiliser System Malfunction

for Preparation Click here


DESCRIPTION

This DTC is output when one of the following occurs: 1) the ECM detects errors in its own communications with the ID code box (immobiliser code box); 2) the ECM detects errors in the communication lines; or 3) the ECU communication ID between the ID code box (immobiliser code box) and ECM is different and an engine start is attempted. Before troubleshooting this DTC, make sure no certification ECU DTCs are present. If present, troubleshoot the certification ECU (smart key ECU assembly) DTCs first.

DTC No.
DTC Detection Condition
Trouble Area
B2799
One of following conditions is met:
  1. Error in communication between ECM and ID code box (immobiliser code box)
  2. Error in communication lines
  3. Communication ID is different between ID code box (immobiliser code box) and ECM during communication
  1. Wire harness or connector
  2. ECM
  3. ID code box (immobiliser code box)

WIRING DIAGRAM


B151007E08


INSPECTION PROCEDURE

NOTICE:
  1. If the ID code box (immobiliser code box) is replaced, register the ECU code and ECU communication ID (Click here).
  2. If the ECM is replaced, register the ECU communication ID (Click here).

1.CHECK DTC OUTPUT
  1. Delete the DTCs (Click here).

  1. Recheck for DTCs.

    OK:
    B2799 output does not recur.



NG
Go to step 2
OK

USE SIMULATION METHOD TO CHECK (Click here)  

2.RE-REGISTER ECU COMMUNICATION ID
  1. Re-register the ECU communication ID (Click here).


NEXT


3.CHECK DTC OUTPUT
  1. Delete the DTCs (Click here).

  1. Recheck for DTCs.

    OK:
    B2799 output does not recur.



NG
Go to step 4
OK

END (ECU COMMUNICATION ID IS DEFECTIVE) 

4.CHECK CONNECTION OF CONNECTOR
  1. Turn the engine switch off.

  1. Check that the connectors are properly connected to the ECM and the ID code box (immobiliser code box).

    OK:
    Connectors are properly connected.



NG
CONNECT CONNECTORS PROPERLY
OK


5.CHECK HARNESS AND CONNECTOR (ID CODE BOX - ECM)


  1. Disconnect the ID code box (immobiliser code box) and ECM connectors.


    B171357E01

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    D31-5 (EFII) - D36-15 (IMO)
    Always
    Below 1 Ω
    D31-6 (EFIO) - D36-16 (IMI)
    Always
    Below 1 Ω
    D31-5 (EFII) - Body ground
    Always
    10 kΩ or higher
    D31-6 (EFIO) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


6.REPLACE ECM
  1. Replace the ECM (Click here).


NEXT


7.REGISTER ECU COMMUNICATION ID
  1. Re-register the ECU communication ID (Click here).


NEXT


8.CHECK DTC OUTPUT
  1. Delete the DTCs (Click here).

  1. Recheck for DTCs.

    OK:
    B2799 output does not recur.



NG
REPLACE ID CODE BOX (IMMOBILISER CODE ECU) (Click here)
OK

END (ECM IS DEFECTIVE)