Home › SECURITIES › ENGINE IMMOBILISER › ENGINE IMMOBILISER SYSTEM (w/ Smart Key System)

DTC    B278A    Short to GND in Immobiliser System Power Source Circuit

for Preparation Click here


DESCRIPTION

This DTC is output when the engine switch power source supply line is open or shorted.

DTC No.
DTC Detection Condition
Trouble Area
B278A
Engine switch power source supply line is open or shorted
  1. Wire harness or connector
  2. Engine switch
  3. Certification ECU (Smart key ECU assembly)

WIRING DIAGRAM


B151005E03


INSPECTION PROCEDURE

NOTICE:
If the certification ECU (smart key ECU assembly) is replaced, register the key and ECU communication ID (Click here).

1.CHECK DTC OUTPUT
  1. Delete the DTCs (Click here).

  1. Recheck for DTCs.

    OK:
    B278A output does not recur.



NG
Go to step 2
OK

USE SIMULATION METHOD TO CHECK (Click here)  

2.CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU - ENGINE SWITCH)


    B178824E04
  1. Disconnect the certification ECU (smart key ECU assembly) and engine switch connectors.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    D40-30 (VC5) - D25-14 (VC5)
    Always
    Below 1 Ω
    D40-40 (AGND) - D25-8 (AGND)
    Always
    Below 1 Ω
    D40-17 (E) - Body ground
    Always
    Below 1 Ω
    D40-30 (VC5) - Body ground
    Always
    10 kΩ or higher
    D40-40 (AGND) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.CHECK HARNESS AND CONNECTOR (ENGINE SWITCH POWER SOURCE)


    B178823E03
  1. Reconnect the certification ECU (smart key ECU assembly) and engine switch connectors.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    D40-30 (VC5) - Body ground
    Key is not in cabin
    Below 1 V
    D40-30 (VC5) - Body ground
    Engine switch pressed
    4.6 to 5.4 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4.CHECK HARNESS AND CONNECTOR (ENGINE SWITCH BODY GROUND)


    B178823E04
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    D40-40 (AGND) - Body ground
    Always
    Below 1 Ω



NG
REPLACE CERTIFICATION ECU (SMART KEY ECU ASSEMBLY) (Click here)
OK

REPLACE ENGINE SWITCH (Click here)