DTC C1434 Steering Angle Sensor Output Malfunction |
| DTC Code | DTC Detection Condition | Trouble Area |
| C1434 | Error in communication between the skid control ECU and the steering angle sensor, or abnormal steering angle sensor zero point. |
|
| 1.CHECK DTC |
Clear the DTCs (Click here).
Turn the ignition switch off.
Turn the ignition switch on (IG) again and check that no CAN communication system DTC is output (Click here).
Start the engine.
Drive the vehicle and turn the steering wheel to the right and left at a speed of 35 km/h (22 mph) and check that no speed sensor or yaw rate and acceleration sensor DTCs are output (Click here).
| Result | Proceed to |
| No CAN communication system, speed sensor, or yaw rate and acceleration sensor DTCs are output | A |
| CAN communication system DTC is output | B |
| Speed sensor or yaw rate and acceleration sensor DTC is output | C |
|
| ||||
|
| ||||
| A | |
| 2.INSPECT STEERING ANGLE SENSOR (POWER SOURCE TERMINAL) |
![]() |
Turn the ignition switch off.
Remove the steering wheel and the column cover lower.
Make sure that there is no looseness at the locking part and the connecting part of the connector.
Disconnect the steering angle sensor connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| D14-4 (IG1) - Body ground | Ignition switch on (IG) | 11 to 14 V |
| D14-5 (BAT) - Body ground | Always | 11 to 14 V |
|
| ||||
| OK | |
| 3.INSPECT STEERING ANGLE SENSOR (GROUND TERMINAL) |
![]() |
Turn the ignition switch off.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| D14-1 (ESS) - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | ||
| ||