VEHICLE STABILITY CONTROL SYSTEM > ABS Warning Light does not Come ON |
| 1.CHECK CAN COMMUNICATION SYSTEM |
Check if a CAN communication system DTC is output (Click here).
| Result | Proceed to |
| DTC is not output | A |
| DTC is output | B |
|
| ||||
| A | |
| 2.CHECK ABS WARNING LIGHT |
Disconnect the skid control ECU connector.
Turn the ignition switch on (IG).
Check that the ABS warning light comes on.
|
| ||||
| OK | ||
| ||
| 3.INSPECT COMBINATION METER ASSEMBLY |
Turn the ignition switch off.
Reconnect the skid control ECU connector.
Perform the Active Test of the combination meter (meter CPU) using Techstream (Click here).
Check the combination meter.
|
| ||||
| OK | ||
| ||