Home › BRAKE › BRAKE CONTROL › VEHICLE STABILITY CONTROL SYSTEM

VEHICLE STABILITY CONTROL SYSTEM > TC and CG Terminal Circuit

for Preparation Click here


DESCRIPTION

Connecting terminals TC and CG of the DLC3 causes the ECU to display the DTC by blinking the ABS warning light.

WIRING DIAGRAM


C167368E01

HINT:
When the warning lights continue to blink, a ground short in the wiring of terminal TC of the DLC3 or an internal ground short in one or more ECUs is suspected.


INSPECTION PROCEDURE

NOTICE:
When replacing the brake actuator assembly, perform zero point calibration (Click here).

1.CHECK CAN COMMUNICATION SYSTEM
  1. Check if a CAN communication system DTC is output (Click here).

    Result:

    Result
    Proceed to
    DTC is not output
    A
    DTC is output
    B



B
INSPECT CAN COMMUNICATION SYSTEM (Click here)
A


2.INSPECT DLC3


    C151827E22
  1. Turn the ignition switch on (IG).

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    D47-13 (TC) - D47-4 (CG)
    Ignition switch on (IG)
    11 to 14 V


    Result:

    Result
    Proceed to
    NG
    A
    OK
    B



B
Go to step 5
A


3.CHECK HARNESS AND CONNECTOR (TC of DLC3 - ECM)


    C167664E01
  1. Turn the ignition switch off.

  1. Disconnect the ECM connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    D47-13 (TC) - D35-23 (TC)
    Always
    Below 1 Ω
    D47-13 (TC) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4.CHECK HARNESS AND CONNECTOR (CG of DLC3 - BODY GROUND)


    C151827E23
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    D47-4 (CG) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


5.CHECK ECM (TC of DLC3 INPUT)


    C151827E22
  1. Turn the ignition switch off.

  1. Reconnect the ECM connector.

  1. Using SST, connect terminals TC and CG of the DLC3.

SST
09843-18040  
  1. Turn the ignition switch on (IG).

  1. Check that the check engine warning light is blinking.

    Result:

    Result
    Proceed to
    Check engine warning light is blinking
    A
    Check engine warning light is not blinking
    B

    HINT:
    If troubleshooting has been carried out according to the Problem Symptoms Table, refer back to the table and proceed to the next step before replacing the part (Click here).



B
REPAIR OR REPLACE WIRE HARNESS OR ECM (TC of ECM CIRCUIT)
A

REPLACE BRAKE ACTUATOR ASSEMBLY (Click here)