Home › SECURITIES › THEFT DETERRENT › THEFT DETERRENT SYSTEM (w/o Smart Key System)

THEFT DETERRENT SYSTEM (w/o Smart Key System) > HOW TO PROCEED WITH TROUBLESHOOTING


HINT:
  1. Use this procedure to troubleshoot the theft deterrent system.
  2. Techstream should be used in step 3.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.CUSTOMER PROBLEM ANALYSIS
    1. Interview the customer to confirm the trouble (Click here).


    NEXT


    3.INSPECT COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM
    1. Use Techstream to check if the CAN communication system is functioning normally (Click here).

      Result:
      Result
      Proceed to
      CAN DTC is not output
      A
      CAN DTC is output
      B



    B.
    GO TO CAN COMMUNICATION SYSTEM (Click here)
    A


    4.SYMPTOM SIMULATION

      NEXT


      5.PROBLEM SYMPTOMS TABLE
      1. If the fault is not listed in the problem symptoms table, proceed to A.

      2. If the fault is listed in the problem symptoms table, proceed to B.



      B.
      Go to step 7
      A


      6.PERFORM TROUBLESHOOTING ACCORDING TO MALFUNCTION SYMPTOM
      1. System description (Click here)

      2. Terminals of ECU (Click here)



      7.ADJUST, REPAIR OR REPLACE

        NEXT


        8.CONFIRMATION TEST

          NEXT

          END