Home › SECURITIES › ENGINE IMMOBILISER › ENGINE IMMOBILISER SYSTEM (w/o Smart Key System)

DTC    B2797    Communication Malfunction No. 1

for Preparation Click here


DESCRIPTION

This DTC is output when an error occurs in communication between the transponder key amplifier and the transponder key ECU.

HINT:
Some noise is found in the communication line.


DTC No.
DTC Detection Condition
Trouble Area
B2797
Keys are positioned too close to each other, or noise occurs in communication line
  1. Key
  2. Transponder key amplifier
  3. Transponder key ECU assembly

WIRING DIAGRAM


B164251E03


INSPECTION PROCEDURE

NOTICE:
If the transponder key ECU is replaced, register the key and ECU communication ID (Click here).

1.CHECK KEYS


    B072873E02
  1. Check whether the ignition key being used is near other ignition keys, as shown in the illustration. Also, check whether the key ring is in contact with the key grip.

    Result:
    Result
    Proceed to
    Key is not near other keys and key ring is not in contact with key grip.
    A
    Key is near other keys and/or key ring is in contact with key grip.
    B



A
Go to step 3
B


2.CHECK DTC OUTPUT
  1. Separate the keys from each other, or remove the key ring.

  1. Delete the DTCs (Click here).

  1. Insert a key into the ignition key cylinder and remove the key. Repeat for all the other keys of the vehicle.

    OK:
    B2797 output does not recur.



NG
Go to step 3
OK

END (KEYS ARE POSITIONED TOO CLOSE TO EACH OTHER) 

3.REPLACE TRANSPONDER KEY AMPLIFIER
  1. Replace the transponder key amplifier (Click here).


NEXT


4.CHECK DTC OUTPUT
  1. Delete the DTCs (Click here).

  1. Recheck for DTCs.

    OK:
    B2797 output does not recur.



NG
REPLACE TRANSPONDER KEY ECU ASSEMBLY (Click here)
OK

END (TRANSPONDER KEY AMPLIFIER IS DEFECTIVE)