DTC B2274 ACC Monitor Malfunction |
| DTC No. | DTC Detection Condition | Trouble Area |
| B2274 | ACC relay actuation circuit inside main body ECU (instrument panel junction block) or other related circuit is malfunctioning |
|

| 1.READ VALUE USING TECHSTREAM |
Connect Techstream to the DLC3.
Turn the engine switch on (IG) and turn Techstream main switch on.
Read the Data List according to the displays on the tester.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| ACC Relay Mon | Status of ACC Relay Monitor / ON or OFF | ON: Engine switch on (ACC) OFF: Engine switch off | - |
|
| ||||
| OK | |
| 2.CHECK ENGINE SWITCH CONDITION |
Check the power source mode changes.
When the key is inside the vehicle and the shift lever is in the P position, check that pressing the engine switch causes the power source mode to change as follows:
|
| ||||
| OK | |
| 3.CHECK DTC OUTPUT |
Delete the DTCs (Click here).
Check for DTCs again.
|
| ||||
| OK | ||
| ||
| 4.INSPECT RELAY (ACC RELAY) |
![]() |
Remove the ACC relay from the instrument panel junction block
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 3 - 5 | When battery voltage is not applied to terminals 1 and 2 | 10 kΩ or higher |
| 3 - 5 | When battery voltage is applied to terminals 1 and 2 | Below 1 Ω |
|
| ||||
| OK | |
| 5.CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - INSTRUMENT PANEL JUNCTION BLOCK) |
Disconnect the D8 connector from the main body ECU (instrument panel junction block).

Disconnect the 1I connector from the instrument panel junction block.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 1I-3 - D8-22 (ACCD) | Always | Below 1 Ω |
| D8-22 (ACCD) or 1I-3 - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 6.CHECK HARNESS AND CONNECTOR |
![]() |
Disconnect the 1A and 1F connectors from the instrument panel junction block.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 1F-10 - Body ground | Always | Below 1 Ω |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 1A-1 - Body ground | Always | 11 to 14 V |
|
| ||||
| OK | ||
| ||