Home › BRAKE › BRAKE CONTROL › VEHICLE STABILITY CONTROL SYSTEM

DTC    C0371    Yaw Rate Sensor (Test Mode DTC)

DTC    C1279    Acceleration Sensor Output Voltage Malfunction (Test Mode DTC)

for Preparation Click here


DESCRIPTION

DTCs C0371 and C1279 can be deleted when the yaw rate and acceleration sensor sends a yaw rate and/or acceleration signal or when Test Mode ends. DTCs C0371 and C1279 are output only in Test Mode.

DTC Code
DTC Detection Condition
Trouble Area
C0371
Detected only during Test Mode.
Yaw rate and acceleration sensor
C1279
Detected only during Test Mode.
  1. Sensor installation
  2. Yaw rate and acceleration sensor

WIRING DIAGRAM

Refer to DTCs C1232, C1243 and C1245 .

INSPECTION PROCEDURE

NOTICE:
When replacing the yaw rate and acceleration sensor, perform zero point calibration (Click here).

1.CHECK YAW RATE AND ACCELERATION SENSOR INSTALLATION
  1. Check that the yaw rate and acceleration sensor has been installed properly (Click here).

    OK:
    The sensor should be tightened to the specified torque.
    The sensor should not be installed in a tilted position.



NG
INSTALL YAW RATE AND ACCELERATION SENSOR CORRECTLY (Click here)
OK


2.INSPECT YAW RATE AND ACCELERATION SENSOR (IG TERMINAL)


    C156491E09
  1. Make sure that there is no looseness at the locking part and the connecting part of the connectors.

  1. Disconnect the yaw rate and acceleration sensor connector.

  1. Turn the ignition switch on (IG).

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    O6-4 (IG) - Body ground
    Ignition switch on (IG)
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR (IG CIRCUIT)
OK


3.INSPECT YAW RATE AND ACCELERATION SENSOR (GND TERMINAL)


    C156491E10
  1. Turn the ignition switch off.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    O6-1 (GND) - Body ground
    Always
    Below 1 Ω

    NOTICE:
    Check the yaw rate and acceleration sensor signal after replacement (Click here).



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR (GND CIRCUIT)
OK

REPLACE YAW RATE AND ACCELERATION SENSOR (Click here)